LightShow 88289 Instructions / Assembly
Contents
1. U S A 1 877 250 9032 MADE IN CHINA PRINTED IN CHINA2. 88289 English pg 1 INSTRUCTIONS IMPORTANT PLEASE READ ALL THE INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT Failure to follow all instructions listed below may result in electric shock fire and or serious personal injury WARNING Not recommended for children under 12 years of age As with all electric products precautions should be observed during handling and use to prevent electric shock IMPORTANT SAFETY INSTRUCTIONS WHEN USING ELECTRICAL PRODUCTS BASIC PRECAUTIONS SHOULD ALWAYS BE FOLLOWED INCLUDING THE FOLLOWING READ AND FOLLOW ALL SAFETY INSTRUCTIONS A CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT OPEN THE COVER NO USER SERVICABLE PARTS INSIDE REFER SERVICING TO QUALIFIED PERSONNEL A WARNING This product is recommended for OUTDOOR USE ONLY Please read this manual carefully prior to using the unit Model 88289 120V 60HZ 0 1A WARNING Read the manual prior to using the unit Keep the manual for further reference Keep the packaging so that you can transport the unit in its original packaging in order to avoid damage This item is very bright Do not shine directly into eyes For outdoor use only Just as a household lamps not for commercial purpose During installation nobody should stand beneath the mounting area Prior to the first use have the unit checked by a qualified person The unit contains voltage carrying parts DO NOT open the light effect 9 Never plug or unplug the unit wit
3. IONS Set up Approximately 1 5 minutes 1 Remove contents from packaging 2 place unit on level floor and install the stake adjust the angle of the stake 3 Pull slide holder out and insert desired Image Slide 4 Plug into receptacle or other outlet device to activate your Projector 5 To deactivate unplug 6 Do not block the cooling fan on bottom or ventilation opening on top of Projector 7 When picture is not clear only adjust the focal length It s on the front of the projector Mounting Instructions 1 Adjust the desired inclination angle via the mounting bracket and fix the bracket screws tightly 2 For the pin spot with plug connect the fixture to the mains with the power plug Outdoor Holiday Projector assembly instructions 1 Assemble the light stake parts A amp B as shown in illustration 1 Push the A and B parts together until tighten the screws 2 Push A through the circle insert the grooves of projector and tighten the circle then adjust the angle of projector 3 Open the lid of the projector turn right or left choose your I J favorite slides in the projector see Illustration 2 i ii Illustration 1 Illustration 2 WARNING This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 this device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause un
4. desired operation pg 3 CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment NOTE This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures e Reorient or relocate the receiving antenna e Increase the distance between the equipment and receiver e Connect the equipment into an outlet on a circuit different from that to which the receiver is connected e Consult the dealer or an experienced radio TV technician for help WARNING CAN ICES 3 B THIS INSTRUCTION SHEET APPLIES TO ITEM NUMBER 88289 Visit WWW GEMMY COM for more information 2014 GEMMY INDUSTRIES CORP 117 WRANGLER DRIVE SUITE 100 COPPELL TX 75019
5. e provided on the circuit s or outlet s to be used for the wet location portable luminaire Receptacles are available having built in GFCI protection and are able to be used for this measure of safety 24 Use only with an extension cord for outdoor use such as an extension cord of cord type SEW SEOW SEOOW SOW SOOW STW STOW STOOW SJEW SJEOW SJIEOOW SJW SJOW SJOOW SJTW SITOW or SJTOOW SAVE THESE INSTRUCTIONS USE AND CARE INSTRUCTIONS ONOnARWN gt pg 2 USER SERVICING INSTRUCTIONS 1 Before using and reusing inspect the product carefully Discard any products that have cut damaged or frayed wire insulation cords cracks lamp holders or enclosures loose connection or exposed copper wire 2 When storing the product carefully remove the product from wherever it is placed including trees branches or bushes to avoid any undue strain or stress on the product conductors connections and wires 3 When not in use store neatly in a cool dry location protected from sunlight USER SERVICING INSTRUCTIONS WARNING Remove all plastic fasteners and tags These are part of the packaging and should be discarded Congratulations You re the proud owner of a outdoor Projector Please read over the directions carefully before using the item e Creates a christmas light show e Lighting effects Fire amp Ice Portable design e LED color white CONTENTS Outdoor Lightshow Projector 1 pc Image Slides 8 pcs INSTRUCT
6. h wet hands 10 Disconnect the unit from the mains prior to replacing the fuse 11 If the plug and or mains lead are damaged they need to be repaired by a qualified technician 12 If the unit is damaged to an extent that you can see internal parts do not plug the unit into a mains outlet 13 Dangers do not attempt to replace the lamp if the lamp is burn out please destroy the unit 14 Only connect this unit to an grounded mains outlet of 120V ac 60Hz 15 Always unplug the unit during a thunderstorm or when it s not in use 16 If the unit has not been used for a longer period of time condensation can occur inside the housing Please let the unit reach room temperature prior to use 17 When you unplug the unit from the mains always pull the plug but not the lead 18 In order to prevent dropping of the unit a safety fastening needs to be installed This can be a solid cable etc which has to be fastened separately from the mounting bracket 19 The supplied bracket is the main fixing and must be used to solidly mount the light effect 20 In order to avoid accidents in public premises the local legal requirements and safety regulations warnings must be fulfilled 21 Keep out of the reach of children 22 When using outdoor use portable luminaires basic safety precautions should always be followed to reduce the risk of fire electric shock and personal injury 23 Ground Fault Circuit Interrupter GFCI protection is to b
Download Pdf Manuals
Related Search