Home
Rod Desyne 3113-661 Installation Guide
Contents
1. ATTACH ROD INTO CENTER SUPPORT BY TURNING ATTACH SUPPORT TO THE ROD INSTALLATION INSTRUCTIONS FOR ONE WAY SINGLE TRAVERSE ROD Drop In A A COLOR BARGER WHEEL The sapport anir doos over ihe po oia teawiih the silver cam lock toward the floor The rod fits into the arm hook and locks in by turning the cam lock with a flat bladed screwdriver Do not turn the Philips screw PARTS LIST 1 Pulley Housing 3 Inside Section of Rod 5 Center Support 7 Slide 2 End Bracket 4 Outside Section of Rod 6 Cord 8 Master Carrier Center Support Adjusting Screws Projection may be adjusted if needed by loosening adjusting screws 6 REMOVAL OF UNUSED CARRIER SLIDES HANG DRAPERIES ONE WAY CORD LEFT ONE WAY CORD RIGHT MOUNTING INSTRUCTIONS Wall mount option Mount the one Center Suppor End brackets Center Support End brackets end bracket and one support to the wall at desired location No center support is needed for installations less than 50 long Ceiling mount option If rod is to be installed to the ceiling attach pulley housing without brackets and stirrup portion of center support directly to the ceiling Push up the end gate to remove carrier slides FOR RODS FULLY EXTENDED TO 50 OR MORE INSTALL CENTER ONE WAY CORD LEFT ONE WAY CORD RIGHT CHILD SAFETY CORD GUIDE RODS WILL NOT WORK PROPERLY WITHOUT GUIDE INSTALLED SUPPORT Guide is pre attached to the cord Mount the guide to the wall at
2. rod and the cord tension pulley Fig 2 Retie knot as close to the Master Carrier as possible then cut off excess cord beyond knot Rotate pulley head until cords are in proper alignment and release into pulley base 1 CLAMP OR CLOTHES PIN 2 CLEAT 3 TIE THE CORD TO ITSELF 4 TIE DOWN DEVICE t Pulley housing
3. the desired height using the included screw Tighten the screw until the cord slides through the device freely See Fig 1 Remove excess slack on the cord by grasping and pulling down on the knot that is on the back side of the master carrier Pull the knot out until the cord is taught in the guide Tie a new knot into the cord as close as possible to the master carrier and cut off the excess cord See Fig 2 CHILD SAFETY CORD GUIDE REMOVAL Pry open the three clips on the back of the device See Fig 3 Split the guide open S gt and remove the cord guide b s m INSTALL ROD INTO END BRACKET drop end a Mo LAT 9 of rod into the u shaped clip of the end bracket To 1S By D remove rod from bracket simply lift the rod out of a m the u shaped clip Spring clip oO 8 Knots End bracket Overlap Joining Master Carrier Knot SPECIAL INSTRUCTION 1 TENSION PULLEY OPTION can be 2 CEILING INSTALLATION If rod is to be installed to ceiling attach pulley housings WARNING mounted to the wall or floor After securing without brackets and stirrup portion of center support directly to ceiling TO AVOID POSSIBLE STRANGULATION KEEP CORDS OUT Tension Pulley to desired location loop OF REACH OF CHILDREN USE THESE DEVICES cord onto pulley wheel Grasp cord joining knot behind Master Carrier and pull out enough cord to take up slack between the
Download Pdf Manuals
Related Search
Related Contents
CONDIÇÕES PARTICULARES gazelle techno 2200 HOJA TÉCNICA Sarnafil® TG 66-15 RADIO SWITCH Lexmark K 1220 Printer User Manual Leur mission : La Caisse Interprofessionnelle du Logement User`s Manual and Instructions TABLE OF CONTENTS Copyright © All rights reserved.
Failed to retrieve file