Ginger 2841/PC Installation Guide
Contents
1. Complement your purchase with these fine accessories also from GINGER Towel Bars Towel Rings Toilet Tissue Holders Hooks Soap Dishes Tumbler Holders Toiletry Shelves G N G H R Grab Bars Mirrors Lights 2001 CARNEGIE AVE Bud Vases SANTA ANA CA 92705 Hotel Shelves 949 417 5207 Shower Curtain Rods www gingerco com Soap amp Bottle Baskets Cabinet Hardware D2841 10 12 Surface INSTALLATION INSTRUCTIONS for Tilting amp Stationary Mirror 2841 GINGER Surfacewecer INSTALLATION INSTRUCTIONS Model TILTING MIRROR INSTALLATION 1 4a Ab 2841 SURFACE TILTING MIRROR Determine location of mirror on wall Position the mounting bracket as illustrated The bracket should be level and in the center of the desired mirror location Mark the location of the moun ting bracket screw holes on the wall 16 1 2 419 gt 6 1 4 160 Position the tilting mechanism as illustrated Mark the location of the mounting screw holes on the wall For drywall installation Using a No 2 Phillips screwdriver push and turn zinc anchors in a clock wise direction untill flush with wall surface If wood cross bracing or a stud is present pre drill a 1 4 6mm diameter hole and install small plastic anchor in place of the zinc anchor For tile or solid wall installation Drill 1 4 6mm on marks made in Step 1 Insert plastic wall anchors and tap flush with wall Position the mo2. unting bracket and the tilting mechanism over the anchors and install screws Swing the tilting mechanism to the vertical position flush against the wall Slide mirror down wall until cross rods are engaged in tilting mechanism and mounting bracket The bracket not the tilting mechanism should support weight of mirror Adjust mounting bracket or tilting mechanism position if necessary SURFACE STATIONARY MIRROR STATIONARY MIRROR INSTALLATION 1 Determine location of mirror on wall 2 Position the mounting bracket as illustrated The bracket should be level and in the center of the desired mirror location Mark the location of the mounting bracket screw holes on the wall 25 7 16 646 3a For drywall installation Using a No 2 Phillips screwdriver push and turn zinc anchors in a clock wise direction untill flush with wall surface If wood cross bracing or a stud is present pre drill a 1 4 mm diameter hole and install small plastic anchor in place of the zinc anchor 3b For tile or solid wall installation Drill 1 4 6mm on marks made in Step 1 Insert plastic wall anchors and tap flush with wall 4 Position mounting bracket over the anchors and install screws 5 Slide mirror down wall until crossrod is supported by the mounting bracket Tools needed Pencil Tape measure Phillios Screwdriver Drill and Level
Download Pdf Manuals
Related Search