Swanstone WK10000.010 Instructions / Assembly
Contents
1. panel 3 4 away from each side wall Vertical jamb panel will cover the gap After positioning follow adhesive venting instructions then final fit by pressing firmly into place After adhesive is applied to panel as instructed DO NOT remove backing from tape Position panel as instructed and press firmly against the wall Pull panel away from the wall and allow the adhesive to dry for three 3 minutes Remove backing from tape and then press panel into final position INSTALLATION PROCEDURE 2 Measure depth of sill area Mark and cut panel to exact size Vaja ee es ee aes i oz e ESLP Frere bir mez P i rs i iS va Se ie f z 5 With vertical jamb panels cut to size apply adhesive per S pattern shown above After following adhesive venting instruc tions remove backing from tape and apply a bead of white caulk to end of panel that overlaps sill Place into position and press down so tape and adhesive make good con tact to wall 3 Cut left and right vertical panels to desired height and depth Lining up with height of tub surround material if applicable NOTE AT THIS POINT IT IS ADVISABL TO TRIAL FIT ALL 3 PANELS i p te fol Bar s il y be P Pat No 4 391 072 6 Caulk cut edges where necessary to seal out moisture It is not necessary to caulk overlapping finished edges unless desired CAUTION Dry cleaning agents and solvents will damage the surf2. Installation procedure for FIBERGLASS WINDOW TRIM KIT WTK 1 BC 8100 Pat No 4 391 072 CAUTION Read ALL instructions BEFORE starting your installation Save this manual for future reference INCLUDED IN THE CARTON Sill panel Right jamb panel Left jamb panel One tube of adhesive One tube of white caulk Installation instructions TOOLS REQUIRED TO INSTALL The only tools needed are a saber saw ruler and caulking DO NOT NAIL PANELS TO SILLS THE HOLES IN THE PANELS ARE FOR MANUFACTURING PURPOSES ONLY INSTALLATION PROCEDURE Allow panels to adjust to room temperature for at least 6 hours 65 90 F Remove unnecessary window moldings if any and clean area of dirt chipped paint loose plaster etc SWAN FIBERGLASS MOLDING COMPOUND IMPORTANT Adhesive Venting Instructions The adhesive manufacturer recommends the following procedure be used to prevent the possibility of adhesive bleed through when attaching to a non porous surface such as ceramic tile or vinyl coated dry wall 1 MEASURE BEFORE YOU START Measure width of sill opening mark and cut 1 1 2 LESS than the measurement Cut off the end with the holes used for manufactur ing purposes el ee ee Ea Be a a ree a a Mls Ari a i f Alt z z 5 pP A Cj sf a 4 Apply adhesive to underside of sill Cushion seal foam strip is factory applied and provides a good seal for uneven edges Be sure to center sill
3. ace Burning cigarettes will damage and discolor the surface Please allow unit to be installed 24 hours before using This will allow proper curing of adhesive and caulking material CARE AND CLEANING Wash regularly with warm water use soft cloth with mild detergent such as Fantastic Mr Clean or Lestoil Scouring pads made of nylon saran or polyethylene may be used but NEVER USE ABRASIVE SCOURING POWDERS CLEANSERS OR PADS THEY WILL DULL THE FINISH Protect finish with any fiberglass wax or automotive paste wax FORM 526 8 85 20M
Download Pdf Manuals
Related Search