Hansgrohe 32040821 Instructions / Assembly
Contents
1. Talis S 32240XX1 ansgrone 20 2 oO v 2 Yy imi 32040XX1 32240XX1 Technical Information Installation Considerations Recommended water pressure 14 7 72 5 psi e For best results Hansgrohe Max water pressure 145 psi recommends that this unit be Recommended hot water temp 120 1 40 F installed by a licensed profes Max hot water temp 176 F sional plumber Hole size in mounting surface 1 1 4 Max mounting surface depth 1 5 8 Please read over these instruc Flow rate lavatory 1 5 gpm tions ce ies ie Flow rate bidet 2 2 gpm ning installation Make sure that Cartridge with high temperature limit stop you have all tools and supplies 3 8 supply hoses needed to complete the instal lation Please know and follow all applicable local plumbing codes when 3 setting the temperature on the water heater Installation Flush the hot and cold supplies thorough ly before installing the faucet Place the faucet and sealing washer on the mounting surface If the mounting surface is less than 3 16 thick trim the sealing washer so that it is even with the bottom of the mounting surface Install the slide washer and collar nut Tighten the collar nut by hand Connect the supply hoses to the hot and cold stops Use two wrenches as shown in the A diagram to prevent hose twisting For proper operation of the faucet the hot supply should be on the left and2. the flange The pivot must face the faucet Turn the drain assem bly if necessary Tighten the retainer nut Place the plunger assembly in the drain Install the horizontal rod so that the end goes through the loop in the bottom of the plunger Install and hand tighten the pivot ball nut Attach the swivel connector to the end of the horizontal rod Attach the swivel connector to the end of the pull rod Position as desired and tighten with a small flat bladed screwdriver User Instructions Pivot the handle up to turn the water on down to turn the water off Pivot the handle to the left for warmer water to the right for colder water Replacement Parts handle 32096000 1 1 screw cover 96338000 2 flange 97406000 3 nut 97209000 4 cartridge cpl 92730000 5 seal 95008000 6 aerator cpl 7 fixing set 96016000 8 connection hose 9 pull rod 96657000 10 ball joint 92036000 11 bidet aerator 13912000 Cleaning Recommendation for Hansgrohe Products Modern lavatory faucets kitchen faucets and showers consist of very different materials to comply with the needs of the market with regard to design and functionality To avoid damage and returns it is necessary to consider certain criteria when cleaning Cleaning Materials for Faucets and Showers Acids are a necessary ingredient of cleaning materials for removing lime however please pay attention to the following points when cleaning f
3. you purchased the product for use primarily for any other purpose including without limitation a commercial purpose this warranty extends only i for 1 year with respect to Hansgrohe and Commercial products and ii for 5 years with respect to AXOR products THIS WARRANTY DOES NOT COVER AND HANSGROHE WILL NOT PAY FOR A Conditions malfunctions or damage not resulting from defects in material or workmanship B Conditions malfunctions or damage resulting from 1 normal wear and tear improper installation improper mainte nance misuse abuse negligence accident or alteration or 2 the use of abrasive or caustic cleaning agents or no rinse cleaning products or the use of the product in any manner contrary to the product instructions 3 Conditions in the home such as excessive water pressure or corrosion C Labor or other expenses for the disconnection deinstallation or return of the product for warranty service or for installa tion or reinstallation of the product including but not limited to proper packaging and shipping costs or for installation or reinstallation of the product D Accessories connected materials and products or related products not manufactured by Hansgrohe TO OBTAIN WARRANTY PARTS OR INFORMATION Contact your Hansgrohe retailer or contact Technical Service at Hansgrohe Inc 1492 Bluegrass Lakes Parkway Alpharetta GA 30004 Tollfree 800 334 0455 In requesting warranty service you wi
4. CTIONS AND QUESTIONS Upon purchase or prior to installation please carefully inspect your Hansgrohe product for any damage or visible defect Prior to installing always carefully study the enclosed instructions on the proper installation and the care and maintenance of the product If you have questions at any time about the use installation or performance of your Hansgrohe product or this warranty please call or write to us or call us toll free at 800 334 0455 ansgrone Hansgrohe Inc e 1490 Bluegrass Lakes Parkway Alpharetta GA 30004 Tel 770 360 9880 Fax 770 360 9887 www hansgrohe usa com US Installation Instructions Part No 90571924 Revised 04 2009
5. aucets and showers e Only use cleaning materials which are explicitly intended for this type of application e Never use cleaning materials which contain hydrochloric formic phosphoric or acetic acid as they cause considerable damage e Never mix one cleaning material with another e Never use cleaning materials or appliances with an abrasive effect such as unsuitable cleaning powders sponge pads or micro fiber cloths Cleaning Instructions for Faucets and Showers Please follow the cleaning material manufacturer s instructions In addition pay attention to the following points e Clean the faucets and showers as and when required e Use the amount of cleaning product and the amount of time recommended by the manufacturer Do not leave the cleaner on the fixture longer than necessary e Regular cleaning can prevent calcification e When using spray cleaners spray first onto a soft cloth or sponge Never spray directly onto the faucet as droplets can enter openings and gaps and cause damage e After cleaning rinse thoroughly with clean water to remove any cleaner residue Important Residues of liquid soaps shampoos and shower foams can also cause damage so rinse with clean water after using Please note if the surface is already damaged the effect of cleaning materials will cause further damage Components with damaged surfaces must be replaced or injury could result Damage caused by improper treatment is not covered und
6. er the warranty Limited Lifetime Consumer Warranty This product has been manufactured and tested to the highest quality standards by Hansgrohe Inc Hansgrohe This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1 1996 and installed in either the United States or Canada WHO IS COVERED BY THE WARRANTY This warranty extends to the original consumer purchaser only This warranty is non transferable WHAT IS COVERED BY THE WARRANTY This warranty covers only your Hansgrohe manufactured product Hansgrohe warrants this product against defects in material or workmanship as follows Hansgrohe will repair at no charge for parts only or at its option replace any product or part of the product that proves defective because of improper workmanship and or material under normal installation use service and maintenance If Hansgrohe is unable to provide a replacement and repair is not practical or cannot be timely made Hansgrohe may elect to refund the purchase price in exchange for the return of the product LENGTH OF WARRANTY Replacement or repaired parts of products will be covered for the term of this warranty as stated in the following two sentenc es If you are a consumer who purchased the product for use primarily for personal family or household purposes this war ranty extends for as long as you own the product and the home in which the product is originally installed If
7. ll need to provide 1 The sales receipt or other evidence of the date and place of purchase 2 A description of the problem 3 Delivery of the product or the defective part postage prepaid and carefully packed and insured to Hansgrohe Inc 1492 Bluegrass Lakes Parkway Alpharetta Georgia 30004 Attention Technical Service if required by Hansgrohe When warranty service is completed any repaired or replacement product or part will be returned to you postage prepaid EXCLUSIONS AND LIMITATIONS REPAIR OR REPLACEMENT OR IN LIMITED CIRCUMSTANCES REFUND OF THE PURCHASE PRICE AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER HANSGROHE NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY PERSON FOR ANY INCIDENTAL SPECIAL OR CONSE QUENTIAL DAMAGES ARISING OUT OF BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY INCLUDING MERCHANTABILITY Some States do not allow the exclusion or limitation of incidental or consequential damages so the above limitation or exclu sion may not apply to you This warranty gives you specific legal rights and you may have other rights which vary from State to State You may be required by law to give us a reasonable opportunity to correct or cure any failure to comply before you can bring any action in court against us under the Magnuson Moss Warranty Act PRODUCT INSTRU
8. the cold supply should be on the right Install the pop up drain and pull rod Turn on the water and check all connections for leaks If desired set the high temperature limit stop Set the High Temperature Limit Stop optional Use a 4 mm Allen wrench to push the screw cover into the handle Use the 4mm Allen wrench to loosen the handle screw 4 complete revolutions Remove the handle Retrieve the screw cover Remove the flange Remove the handle screw Remove the high temperature limit stop Replace the high temperature limit stop so that the pin on the cartridge is in the desired slot on the limit stop Note the temperatures given in the dia gram assume a water heater temperature of 140 F a cold water temperature of 50 F and a water pressure of 45 PSI Replace the flange Replace the handle screw Use the Allen wrench to turn the screw 4 revolutions Replace the handle Tighten the handle screw Turn on the water and test the faucet Install the pop up drain Remove the plunger assembly Unscrew the drain outlet flange from the tee Unscrew the tailpiece from the tee Wrap the threads with Teflon tape and replace Install the white flexible sealing gasket to the flange Place it in the sink outlet Install the black mack gasket white friction ring and retainer nut on the flange Do not tighten the nut against the bottom of the sink at this time Thread the tee and tailpiece to
Download Pdf Manuals
Related Search