Bellaterra Home 804380-WH Instructions / Assembly
Contents
1. ASSEMBLY amp INSTALLATION INSTRUCTIONS 804380 INTRODUCTION Thank you for selecting our BELLATERRA HOME product To ensure that your installation occai smoothly read these instructions carefully before you begin also review the recommended tools and materials section carefully unpack and examine your new plumbing fixture ALL INSTALLATION PROCEDURES MUST COMPLY IN STRICT ACCORDANCE WITH APPLICABLE LOCAL PLUMBING AND BUILDING CODES Tools and materials Required Roughing in Dimensions Most of the procedures require the use of availabie from hard ware and piumbing supply stores it is essential that the tools and matenals be on hand before work is begun NDO Adjustable wrench Saber Saw Plumbers Putty or Caulking Channel Locks qi Putty Knife Pipe Wrench 1410mm 55 1 2 82 11 16 Measure CA Hacksaw Regular Screwdriver Phillips Screwdriver x x x x x x x x x Dimensions shown for location of supplies and P trap are suggested 1 804380 Step One Use the track level bar tape measure and pencil to mark holes in desired location Having established the position use drill to make holes Use the hammer to insert anchors into the hole and screw in the screws Finally put the mirror in place Step Two Place the vanity in position Level vanity ensuring i2. t is level with water outlets and piping f the doors are out of alignment they can be fixed by adjusting the hinges Step Three Fix the vanity to the wall through the back rail of the cabinet for wall hung units The fixings should be placed on a wall stud Werecommend that you use a toggle or toggle type system if you can t located a strong solid surface Step Four For undermount sink unit Glue the undermount sink to the Stone Top in suitable place put them on the cabinet after the glue is dry Make sure the sink and stone stick to each other strong enough For semi recessed basin unit Put the basin on the cabinet in suitable place Glue the basin to the cabinet if necessary For above counter basin unit Put the stone top on the cabinet and place the basin on stone in suitable place Step Five If has board shelf Use the track level bar tape measure and pencil to mark holes in desired location Having established the position use drill to make holes Use the hammer to insert anchors into the hole and screw in the screws Finally put the board shelf in place SG ss l A fa NE Code G 2 3 Sw Rg Component Accessory list Expended Hexagon Name p go partides Wall hung Iron screw QTY 2 2 Eo 804380 Install faucet and drain in accordance with manufacturer s instructions Ensure all water supply and drain connections are tightened T
3. urn on water supply valves and water test installation Typical Drain Assembly Connect the trap to the drain assembly hand tight to check alignment It may be necessary to cut off part of the tailpiece area A or part horizontal leg of the trap area B Trap joints for watertight assembly Connect hot and cold supply lines to the shut off valves Tighten 3 804380
Download Pdf Manuals
Related Search