Hampton Bay 42010 Troubleshooting Guide
Contents
1. Troubleshooting Problem Solution o The fan will not start The fan is noisy The fan wobbles The light are not dimming The lights are flickering The wiring diagram is confusing or incorrect Check the main and branch circuit fuses or breakers Check the line wire connections to the fan and switch wire connections in the switch housing Check the battery in the remote control Ensure you are in the normal range of 10 20 feet Remember to turn off the power supply before checking the dip switch settings Ensure all motor housing screws are snug Ensure the screws that attach the fan blade bracket to the motor hub are tight Ensure the wire nut connections are not rattling against each other or the interior wall of the switch housing Allow a 24 hour breaking in period Most noises associated with a new fan disappear during this time If you are using the Ceiling Fan light kit ensure the screws securing the glassware are tight Check that the light bulbs are also secure Ensure the canopy is a short distance from the ceiling It should not touch the ceiling Ensure your outlet box is secure and rubber isolator pads were used between the mounting plate and outlet box Check that all blade and blade arm screws are secure Most fan wobble problems are caused when blade levels are uneq2. ual Check this level by selecting a point on the ceiling above the tip of one of the blades Measure from a point on the center of the blade to the point on the ceiling Rotate the fan until the next blade is positioned for measurement and measure from the same point on each blade to the ceiling Repeat for each blade Any measurement deviation should be within 1 8 in Run the fan for ten minutes If the fan continues to wobble please contact Home Decorators Collection Customer Service and a balancing kit will be sent to you at no charge Remove the battery cover from the back of the remote control and verify that the ON DIM dip switch is set to DIM You must use incandescent light bulbs 60 watt max in order to use the dimming function If you are using CFL light bulbs open the back of the remote control and verify that the ON DIM dip switch is set to the ON position If you wish to use the DIM feature change the light bulbs to 60 watt max incandescent bulbs Download the current generation of the wiring diagram located in the installation manaul The receiver is Recheck the wire connections clicking
Download Pdf Manuals
Related Search