the great outdoors by Minka Lavery 73106-143C-L Instructions / Assembly
Contents
1. INSTALLATION INSTRUCTIONS For Model 73106 143C L READ AND SAVE THESE INSTRUCTIONS WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AVERTISSEMENT COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR HANGING THE FIXTURE Fig 1 1 Shut off the power at the circuit breaker and remove the old fixture including the mounting hardware 2 Carefully unpack your new fixture and lay out all the parts on a clear area Take care not to lose any small parts necessary for installation CONNECTING THE WIRES Fig 2 3 While supporting the fixture connect the electrical wires as shown in Fig 2 making sure that all wire connectors are secured If your post has a ground wire green or bare copper connect the fixture ground wire to it If not consult your electrician for proper grounding After wires are connected tuck them carefully inside the post cup I 4 Secure the post cup H to post 1 with the screws H 5 Bulb information 1 x AC LED 10W included DO NOT EXCEED THE MAXIMUM WATTAGE RATING NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE COMPLETING THE INSTALLATION Fig 1 6 Remove the fixture frame A from the fixture body E by unscrewing the screws G then attach the small glass C and large glass F into the fixture frame A with clips B 7 Place the small round glass D over the LED module 8 Re attach fixture frame A to the fi2. xture body E with screws F Replacing LED module Fig 3 The LED module can be replaced by a qualified electrician and shut off the power at the circuit breaker and remove fixture from the post without cutting of wire and without damage to any decorative element to which the fixture is attached See installation steps for more details Fig 3 1 Remove the fixture frame A by loosening screws F Fig 1 Remove the small round glass D 2 Disconnect the fixture wires and the supply wires then unscrew the screw Q 3 Remove screws l to disassemble the module cover J glass K module ring L LED module M and the metal support O 4 Carefully remove the LED module for re lamping Note The LED module should be provided by a specified supplier 5 For better heat dissipation the LED module should be installed with the heat transfer material N when re lamping Your installation is now complete Return power to the junction box and test the fixture ar american i i D lighting intertek EE ociation
Download Pdf Manuals
Related Search