the great outdoors by Minka Lavery 72424-212 Instructions / Assembly
Contents
1. 9 Carefully lace the fixture s wires through the chain Feed the fixture wires through the loop and nipple assembly CONNECT THE WIRES Fig 3 10 Connect the electrical wires as shown in Fig 3 making sure that all wire connectors are secured If your outlet box has a ground wire green or bare copper connect the fixture s ground wire to it Otherwise connect the fixture s ground wire directly to the crossbar using the green screw provided 11 Tuck these wire connections neatly into the ceiling outlet box and then raise the canopy all the way to the ceiling Raise the lock collar and thread onto ceiling loop protruding through canopy Fig 2 COMPLETING THE INSTALLATION Fig 1 12 Pull up the latch A and open the door 13 Install 3 60W B10 5 bulb s not included in accordance with the fixture s specification DO NOT EXCEED THE MAXIMUM WATTAGE RATING NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE 14 When replacing the glass B pull up the latch A and open the door Loosen the clips and remove glass B After replacing the glass re tighten the glass clips and then close the door 15 For installing or replacing bulbs at a later date pull up the latch A and open the door Fig 1 Your installation is now complete Return power to the junction box and test the fixture Note Illustration Fig 1 on this manual is for installation purposes only It may or may not be identical to the fixt2. INSTALLATION INSTRUCTIONS For Model 72424 212 Rev 06 19 2013 READ AND SAVE THESE INSTRUCTIONS W AR N I N G S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E AK E R AVERTISSEMENT COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR Fig 1 Fig 2 Fig 3 PREPARING FOR INSTALLATION Fig 2 1 Shut off the power at the fuse box or circuit breaker box and remove the old fixture from the ceiling including the mounting hardware 2 Carefully unpack your new fixture and lay out all the parts in a clear area Take care not to misplace any small parts necessary for installation 3 Thread the nipple into the ceiling loop until snug 4 Thread the other end of the nipple into the crossbar until snug Note The length of the nipple into the crossbar may be adjusted if necessary 5 Use the lock washer and hex nut to secure the nipple into the crossbar 6 Take this crossbar assembly and mount it to ceiling outlet box with mounting screws Size 8 32N L0 5 The side of crossbar marked with GND must face out 7 Determine the desired hanging height and use a pair of proper chain pliers to remove and discard the excess chain 8 Open one end of chain and attach it to the fixture ceiling loop and close the chain Slip the canopy and lock collar over the chain and allow them to rest on the fixture body Open the other end of the chain and attach it to chain loop and close the chain
3. ure purchased LA 2328E FIXTURE WIRES Black or Smooth HOUSE WIRES Black Hot FIXTURE WIRES White or Ribbed HOUSE WIRES White Neutral FIXTURE WIRES Bare Copper Ground HOUSE WIRES Green Ground A B Set A 010 Crossbar Ground screw Mounting Screw 2 Chain HCH2072 212 Ceiling Loop Canopy Outlet Box Mounting Screw Nipple Lock Collar Crossbar Hex Nut Lock Washer Wire Chain Loop
Download Pdf Manuals
Related Search