Sea Gull Lighting 94552-965 Installation Guide
Contents
1. Installation And Safety Instructions LR 145 Line art shown may not exactly match the fixture enclosed However the installation instructions do apply to this fixture Fill in Item Number on Carton and File This Sheet For Future Reference ITEM 072808 IMPORTANT SAFETY INSTRUCTIONS ADAPTER CAP A e Be sure the electricity to the system you are working on is turned off either the fuse removed or the circuit breaker set at off AMBIANCE e Use of other manufacturers components will void warranty listing A and create a potential safety hazard RAIL RAIL e If you are unclear as to how to proceed contact a qualified STRAIN ADAPTER R electrician RELIEF Ps e For use with the 120V Transitions track series by Sea Gull Lighting SCREW P COLLAR J e Caution To reduce the risk of a burn during relamping remove from the track before relamping e Minimum distance from the front of the lamp to combustible SPLICE surfaces is 8 lt COMPARTMENT gt e Make sure all connections are tight 1 e Dimming halogen lamps greatly reduces lamp life e To reduce the risk of FIRE or INJURY TO PERSONS Turn off and allow to cool before replacing lamp e Turn off and allow to cool before replacing lamp e Lamp gets HOT quickly Contact switch only when turning on e Do not touch hot lens guard or enclosure e Do not touch the lamp at any time Use a soft cloth Oil from skin may damage lamp e Keep lamp away from materials t2. ail adapter R by cutting wire just below the rail adapter R 2 Slide collar O canopy G mounting bar F nipple V and lockwasher amp hexnut U over wire to the top of the splice compartment I in that order Install strain relief H to wire Tighten strain relief set screws with a flat head screwdriver Secure mounting bar F to outlet box with outlet box screws not supplied Make electrical connections using silicone wire nuts or other UL listed device Be sure that no wires are left exposed a House Black to Fixture Black b House White to Fixture White c House Ground to Green Ground Screw Make sure that no wires are left exposed Raise canopy G against ceiling and secure by threading collar O to nipple V ATTACH PENDANT TO RAIL REFER TO FIGURE 3 Unthread adapter cap A from rail adapter R Making sure contacts K will align with conductors L on rail set the bottom of the the rail adapter R to the bottom of the rail and roll rail adapter R up onto the rail Install fixture to rail by closing rail adapter R over rail Thread adapter cap A back onto rail adapter R tightly E o D M o FIXTURE INSTALLATION CORRECT INCORRECT ADAPTER CONTACTS K CONTACTS K ADAPTER CAP A CONDUCTOR L CONDUCTOR L FIGURE 3
3. hat may burn e Do not operate the luminaire fitting with a missing or damaged shield e Save these instructions FIGURE 1 NOT INCLUDED GROUNDING AND MOUNTING EAR 1 Determine length of pendant and shorten cable from the splice compartment I Be sure to add 5 for electrical connections LOC K U P FOR OPTIONAL when installing with canopy G MONO POINT CANOPY 2 Unthread top of splice compartment I Set strain relief collar at desired location NOTE Strain relief collar is threaded and should be threaded up and down cable Be sure of cable jacket is protruding out of strain relief collar Secure in place by tightening the two set screws 3 Make connections between socket leads and pendant cable using wire nuts inside the splice compartment a Black to Black b White to White iN im CONNECTORS c Ground to Ground Make sure no wires are left exposed and carefully tuck wire nuts amp lt ___ QUTLET BOX into bottom half of splice compartment I SCREWS 4 Close splice compartment I by threading the two halves GROUND WIRE together 5 Install optional shade not included over socket Q Follow NIPPLE V applicable instructions provided with shade 6 Install lamp MRC16 GU10 50 watt not supplied into socket Q STRAIN RELIEF H MOUNTING F BAR F LOCKWASHER ia MONO POINT amp HEXNUT U CANOPY G COLLAR 0 gt FIGURE 2 NOT INCLUDED FOR MONO POINT INSTALLATION Fig 2 LR 145 1 Remove r
Download Pdf Manuals
Related Search