Aspects TPDW110050LBK Installation Guide
Contents
1. HD Supply Outdoor Wall Pack Fluorescent Wall Sconce Model 326912 amp 326930 TPDW70050LBK TPDW110050LBK 120VAC 60Hz Safety Precautions This fixture is designed for use in a 110 120VAC 60Hz fused circuit Read all safety precautions and installation instructions carefully Do not use on a dimming circuit before installing or servicing this fixture Failure to comply with these instructions could result in potentially fatal electric shock and or To reduce the risk of electrical shock and to assure proper operation property damage this fixture must be adequately grounded To accomplish proper l D E a l grounding there must be a separate ground wire green contact fixture must be wired in accordance with all national and local supply panel electrical codes na ae ee l l l l This fixture is intended to be used for general outdoor lighting in wet Do not handle any energized fixture or attempt to energize any fixture locations with wet hands or while standing on a wet or damp surface or in water ASSEMBLY INSTRUCTIONS 1 Preparing for installation A Disconnect electrical power at fuse or circuit breaker box before installing or servicing any part of this fixture B Carefully remove the fixture from the carton 2 Wiring all wiring must take place inside junction box not included Caution Make sure power is off at fuse or circuit breaker box Check power wires for damage or scrapes If power supply wires are within th2. ncurred in transit 1 of 1 8060665 RO American Fluorescent l iF j design efficiency technology ii
3. ree inches of the ballast power supply use wire suitable for at least 90C 194F Note Most dwellings built before 1985 have supply wire rated to 60C Consult a qualified electrician before installing A Secure fixture arm 2 on the threaded cover 3 not supplied with locknut 4 supplied B Make all wire connections to appropriate wire Secure with wire nuts included C Connect the green wire from the fixture to the power source green wire D The black wire from the fixture is connected to the black wire from power source E The white wire from the fixture is connected to the white neutral wire from power source F Tuck all connections neatly into junction box G Secure threaded cover 3 on the junction box with two screws not supplied a NOT SUPPLIED 5 Positioning Fixture with the Swivel Arm Assembly A Loosen the thumb nut on the swivel arm assembly base Adjust the correct fixture aiming angle position by rotating it upward or downward 6 Restore power at fuse or circuit breaker box Limited Factory Warranty American Fluorescent Corporation warrants this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period of 2 years from date of purchase This warranty covers all component parts and extends only to replacement of defective fixture or components it does not cover failure due to improper installation misuse mishandling or damage i
Download Pdf Manuals
Related Search