Minka Lavery 3134-207 Installation Guide
Contents
1. INSTALLATION INSTRUCTION F OR FIXTURE 3134 207 READ AND SAVE THESE INSTRUCTIONS WARNING SHUT OFF THE POWER AT FUSE OR CIRCUIT BREAKER ASSEMBLY THE FIXTURE FIG 2 1 Carefully unpack your new fixture and lay out all the parts in a clear area Take care not to lose any small parts necessary for installation 2 Thread the nipple M into the coupling O then install the glass bobeche N knurled nut C over the nipple M and fix them with the fixture loop A tightly 3 Thread the nipple I into the coupling P tightly 4 Insert the rubber washer Q and glass bobeche J over the nipple 1 and lock it in place by the finial K then hook the crystal drop L to the small ring R 5 Insert the candle cover E over the socket F then put the glass bobeche D set over the socket F well 6 Install the light bulb in accordance with fixture s specifications DO NOT EXCEED THE MAXMUM WATTAGE RATING 7 Hook the crystal drop H to the small ring G MOUNTING THE FIXTURE FIG 1 1 Shut off the power supply at the fuse box or circuit breaker box Remove the old fixture from ceiling Including the cross bar 2 Thread the nipple V into the collar loop W until snug 3 Thread the other end of nipple V into the cross bar S properly 4 Place lock washer T over the end of nipple V protruding through cross bar S and thread hex nut U onto nipple V until tight 5 Take this crossbar assembly and2. mount to ceiling outlet box Y using outlet box screw Z tightly The side of cross bar marked with GND must face out 6 Use proper chain pliers to open one end link of the chain and connect to the fixture loop A Close the link 7 By measuring determine correct number of links needed for proper hanging height Using pliers disconnect and discard remaining chain 8 Lace the fixture wires through the chain AA 9 Slip collar ring AB over the chain AA then do the same with canopy X 10 Open the other end link of the chain AA and connect to the collar loop W Close the link 11 Feed the fixture wires through the collar loop W and nipple V and pull until taut CONNECTING THE WIRE See fig 3 1 Take the black wire from the ceiling outlet box and the smooth wire leg from the fixture and twist bare ends together Twist wire connector onto end of wire until snug 2 Repeat same process with white junction box wire and ribbed wire leg of fixture wire NOTE Twist wire together in the same direction then twist the wire connector onto wire 3 If your outlet box has a grounding wire Green or bare copper Attach this wire and the bare copper wire from the fixture together as step 1 If outlet box has no ground wire Attach the bare copper fixture wire to the green ground screw on the cross bar 4 Tuck these wires connectors neatly into the ceiling out let box and raise the collar ring AB and thread onto colla
3. r loop W protruding through canopy Your installation is now complete Return power to the junction box and test the fixture american D lighting LISTED association Fig 2 FIXTURE LOOP A KNURLED NUT C M NIPPLE N GLASS BOBECHE O COUPLING GLASS BOBECHE D CANDLE COVER E SOCKET SMALL RING G 4 A ss i Pd j i CRY STAL DROP H NIPPLE I GLASS BOBECHE FINIAL K P COUPLING f QRUBBER WASHER R SMALL RING CRYSTAL DROP L AA AB FIXTURE LOOP A WIRES W EOR M RIBBED Notice It is important to use proper chain pliers not included to OPEN and CLOSE the chain included with this fixture Do not open them with other tools that may twist or stress the chain links It is important to use proper chain pliers like the ones shown in the diagram
Download Pdf Manuals
Related Search