Minka Lavery 4757-206 Installation Guide
Contents
1. INSTALLATION INSTRUCTIONS FOR 4757 206 WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER ASSEMBLING THE FIXTURE Fig 2 Fig 1 1 Return the six arms to suitable position see figure 2 2 Attach the loop I to the fixture body F by tuming it clockwise until tight 3 Attach the arms K to the bottom of the fixture body F and lock it securely with the check ring L attach the twist tubing J through the center of the arms K and turn it clockwise until tight Then attach the small loop H of the acrylic ball to the center twist tubing J 4 Place the candle sleeve E and the spider ring D over the socket of the fixture body F then lock it securely with the check ring C Install the light bulb NOTE DO NOT EXCEED THE SPECIFIED WATTAGE Max 6 60w and put the glass shade B on to the spider ring D then put the decorative frame A over the glass shade B 5 Attach the crystal G to the small ring of the arm as shown HANGING THE FIXTURE Fig 1 1 Shut off the power at the circuit breaker and remove old fixture from ceiling including the old crossbar 2 Carefully unpack new fixture and lay all the parts on a clear surface 3 Thread nipple C into loop F until snug 4 Thread other end of nipple C with loop attached into crossbar D until snug 5 Place lock washer B over end of nipple protruding through crossbar A A and thread hex nut A onto nipple until tight Fig 2 I2. O A 6 Take this crossbar assembly and mount to ceiling junction box with f junction box screws E Tighten screws securely with screwdriver HA 7 Using proper chain pliers to open one end link of the chain provided and connect to the fixture loop J Close the link 8 By measuring determine correct number of links needed for proper hanging height Using proper chain pliers disconnect and discard remaining chain 9 Lace the fixture wires through the chain 10 Slip loop collar H over the chain then do the same with the canopy G 11 Open the other end link of the chain and hang the fixture on the loop at the ceiling Close the link 12 Feed the fixture wires through the loop F and nipple C and pull until taut CONNECTING THE WIRES Fig 3 1 Take the black wire from the ceiling junction box and the smooth wire leg from the fixture and twist bare ends together Twist wire connector onto end of wire until snug 2 Repeat same process with white junction box wire and ribbed wire leg of fixture wire NOTE Twist wires together in the same direction you twist the wire connector onto wires 3 If your junction box has a grounding wire green or bare copper attach this wire and the bare copper wire from the fixture together as CHAIN HUNG FIXTURE INSTRUCTION step 1 If junction box has no ground wire attach the bare copper Notice It is important to use pr
3. oper chain pliers not fixture wire to the green ground screw on the crossbar included To OPEN and CLOSE the chain included with 4 Tuck these wire connections neatly into the ceiling outlet box and i then raise the canopy G all the way to the ceiling Raise the loop this fixture Do not open them with other tools that may H and thread onto ceiling loop protruding through canopy twist or stress the chain links It is important to use proper Your installation is now complete Return power to the junction box chain pliers like the ones shown in the diagram and test the fixture Fig 3 Daa FIXTURE FIXTURE FIXTURE T aa WIRES WIRES WIRES Black or White or Bare z Smooth Ribbed Copper 4 HOUSE HOUSE Ground HOUSE UL american WIRES WIRES WIRES lighting Black White Green or LISTED association Hot Neutral Bare Copper Ground
Download Pdf Manuals
Related Search