Minka Lavery 4392-77 Instructions / Assembly
Contents
1. INSTALLATION INSTRUCTIONS For Model 4392 4394 READ AND SAVE THESE INSTRUCTIONS ARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER ASSEMBLING THE FIXTURE Fig 3 1 Shut off power at the circuit breaker and remove old fixture including the crossbar OUTLET BOX CEILING 2 Carefully unpack your new fixture and lay out all the parts on a clear area Take care not to lose any small parts necessary for installation 3 Thread fixture loop l onto stud of the fixture until tight Attach glass L to the inner side of fixture arm M align the holes then secure by threading the two screws K with plastic washer J until snug Repeat for the other panels 5 Install the bulbs in accordance with the fixture s specification DO NOT EXCEED THE MAXIMUM WATTAGE RATING HANGING THE FIXTURE Fig 1 6 Thread nipple C into ceiling loop E until snug 7 Place lock washer B over end of nipple C protruding through crossbar F and thread hex nut A onto nipple C until tight Take this crossbar F assembly and mount to ceiling outlet box with outlet box screws G Tighten screws securely with screwdriver The side of the crossbar marked GND must face out 8 Use a pair of pliers to open one end link of the chain provided and connects to the fixture loop 1 Close the link 9 By measuring determine correct number of links needed for proper hanging height Using pliers disconnect and discard remaining chain 10 Lac2. ain included with this fixture Do not open them with other tools that may twist or stress the chain links It is important to use proper chain pliers like the ones shown in the diagram box and test the fixture
3. e the fixture wires through the chain 11 Slip loop collar H over the chain then do the same with canopy D 12 Open the other end link of the chain and connects to the ceiling loop E Close the link 13 Feed the fixture wires through the loop E and nipple C and pull until taut CONNECTING THE WIRES Fig 2 14 At this point connect the electrical wires as follow take the black wire from the outlet box and the smooth wire leg from the fixture and twist bare ends together Twist wire connector onto end of wire until snug Repeat same process with white outlet box wire and ribbed wire leg of Fig 2 fixture wire NOTE Twist wires together in the same direction you WIRES WRES WIRES g Po Ribbed Copper twist the wire connector onto wires If your outlet has a ground wire z Seni green or bare copper connects fixture s ground wire to it Otherwise connect fixture s ground wire directly to the crossbar using the green W Neutral Ra ae screw provided Ground 15 Tuck these wire connections neatly into the ceiling outlet box and american a a hghti ng association then raise the canopy D all the way to the ceiling Raise the lock LisTeo collar H and thread onto ceiling loop E protruding through canopy Intertek D Your installation is now complete Return power to the junction Notice it is important to use proper chain pliers not included To OPEN and CLOSE the ch
Download Pdf Manuals
Related Search