Minka Lavery 2901-613-L Instructions / Assembly
Contents
1. be replaced by a qualified electrician without cutting the wire and without damaging the decorative element to which the fixture is attached See installation steps for more details Fig 3 Warning Turn off power at the fuse box or circuit breaker before replacing the LED module a d Note The LED module should be provided by a specified supplier To remove the fixture from the wall loosen screws E and remove the wire connectors Then place the fixture on a clear flat surface Loosen screws P and remove frame L and glass shade K Loosen screws J screws M wire fastener N and carefully remove LED module l Reverse steps a c for installing the new LED module Fig 1F JUNCTION Mounting plate Green screw junction box screw 2 Fig 2 FIXTURE WIRES Black v FIXTURE WIRES White HOUSE WIRES White Neutral FIXTURE WIRES Green or Bare Copper Ground HOUSE WIRES Green or Bare Copper Ground v IMPORTANT Fixture should be installed by a qualified electrician to ensure proper wiring and installation Dimmable with C L CFL amp LED type and Incandescent Halogen type dimmers D Intertek I american fightin ighting association2. INSTALLATION INSTRUCTIONS FOR 2901 613 L For LED Wall Mount Fixture WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AVERTISSEMENT COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DO DISJONCTEUR MOUNTING THE FIXTURE Fig 1 1 Shut off power at the fuse box or circuit breaker box If necessary remove the existing fixture and its mounting hardware from the wall Carefully remove the new fixture from the carton and check that all parts are included as shown in the illustration Attach the circular strap A to the outlet box using outlet box screw B Size 8 32 1 2 L The side of the circular strap marked GND must face out CONNECTION THE WIRES Fig 2 4 Connect the electrical wires as shown in Fig 2 making sure that all wire connectors are secured If your outlet has a ground wire green or bare copper connect the fixture s ground wire to it Otherwise connect the fixture s ground wire directly to the circular strap using the green screw provided After the wires are connected tuck them neatly into the outlet box FINISHING THE INSTALLATION Fig 1 5 Align the fixture D over circular strap A and secure with screws E Your installation is now complete Return power to the outlet box and test the fixture CAUTION ATTENTION When handling the fixture do not apply pressure to the LEDs Hold the fixture by the base or fixture body E only Replacing LED module Fig 3 The LED module can
Download Pdf Manuals
Related Search