Minka Lavery 2933-84-L Instructions / Assembly
Contents
1. INSTALLATION INSTRUCTIONS FOR 2933 L For LED Wall Mount Fixture WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AVERTISSEMENT ICOUPER LE COURANT AU NIVEAU DES FUSIBLES OU DO DISJO PREPARATION Fig 1 1 Shut off power at the fuse box or circuit breaker box If necessary remove the existing fixture and its mounting hardware from the wall 2 Carefully remove the new fixture from the carton and check that all parts are included as shown in the illustration 3 Position mounting plate A on the wall and mark the location of the two drywall anchors G Pre drill the holes for the drywall anchors G Then insert the drywall anchors G into the wall HANGING THE FIXTURE Fig 1 4 Attach the mounting plate A to the outlet box using outlet box screws B Size 8 32 1 2 L The side of the mounting plate marked GND must face out 5 Place the wood screws F through the holes of the mounting plate A and into the drywall anchors G to secure the mounting plate A to the wall CONNECTION THE WIRES Fig 2 6 At this point connect the electrical wires as shown in Fig 2 making sure that all wire connectors are secured If your l outlet box has a ground wire green or bare copper connect Fig 2 the fixture s ground wire to it Otherwise connect the JUNCTION Set A 021 595140 Mounting plate Green screw Wood screw 2 Plastic drywall anchors 2 Mounting screw 2 fixture s ground wire direc2. ian to ensure proper wiring and installation Dimmable with C L CFL amp LED type and Incandescent Halogen type dimmers american fighti Telebdlale ghting association Il 798
3. tly to the mounting plate using the FIXTURE r FIXTURE green screw provided After the wires are connected tuck them carefully into the outlet box FINISHING THE INSTALLATION Fig 1 7 Align Fixture E over mounting plate A and secure with screws D Your installation is now complete Return power to the outlet box and test the fixture CAUTION ATTENTION When handling the fixture do not apply pressure to the LEDs Hold the fixture by the base or fixture body E only Replacing LED module Fig 3 The LED module can be replaced by a qualified electrician without cutting the wires and without damaging the decorative element to which the fixture is attached See installation steps for more details Fig 3 Warning Turn off power at the fuse box or circuit breaker before replacing LED module a To remove the fixture from the wall loosen screws D and remove the wire connectors Then place the fixture on a clear flat surface b Loosen screws P hex nuts F screws M wire fastener N and then carefully remove LED module I c Reverse steps a b for installing the new LED module Note The LED module should be provided by a specified supplier WIRES Black FIXTURE WIRES White HOUSE WIRES White Neutral WIRES Green or Bare Copper Ground HOUSE WIRES Green or Bare Copper Ground Fig 3 SS pe IMPORTANT Fixture should be installed by a qualified electric
Download Pdf Manuals
Related Search