the great outdoors by Minka Lavery 9802-144 Installation Guide
Contents
1. INSTALLATION INSTRUCTIONS FOR 9802 PL For Wall Sconce Fixture READ AND SAVE THESE INSTRUCTIONS WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER MOUNTING THE FIXTURE Fig 1 1 Shut off power at the fuse box or circuit breaker box If necessary remove old fixture and all mounting hardware from wall junction box 2 Carefully unpack your new fixture and lay out all the parts on a clear area Take care not to lose any small parts necessary for installation 3 Attach the crossbar to the junction box with the two junction box screws as shown The side of the crossbar marked GND must face out 4 Thread the nipple part way into the center hole of the crossbar 5 Connect the wires as described under Connecting the Wires CONNECTING THE WIRES Fig 2 6 Connect the fixture wires to the junction box wires as shown in the Fig 2 Make sure all wire connectors are secured and do not easily pull off with a slight tug If there is no green ground wire from the junction box connect the fixture ground wire to the crossbar with the green screw provided 7 To prevent moisture from entering the outlet box and causing a short use clear caulking i e Indoor Outdoor silicone sealant to outline the outside of fixture backplate where it meets the wall leaving a space at bottom to allow moisture a means to escape Fig 4 COMPLETING THE INSTALLATION Fig 1 8 Place the fixture over the nipple so the nipple protrudes through the center ho2. le Holding the fixture in place thread the cap nut onto the end of the nipple until fixture is secured to the wall 9 Install the PL lamp in accordance with the fixture s specification 1xMax26W included DO NOT EXCEED THE MAXIMUM WATTAGE RATING 10 The ballast in each of these models can be replaced by a qualified electrician without cutting of wires and without damage to the housing trim decorative elements or carpentry to which the fixture is attached See installation steps for more detail The ballast and lamp are combined to replace or install twist pins into socket as shown on Fig 3 11 Place the glass with the marked arrow on the topside into the fixture Then secure the steel bar with screws and plastic washer 12 This fixture contains an integrated photo sensor that automatically prevents operation during daylight hours 13 This fixture is rated for a minimum start temperature of 17 Celsius 14 This fixture is UL Listed for Wet Location applications Your installation is now complete Return power to the junction box and test the fixture LIMITED 2 YEAR WARRANTY This Fixture is covered by a Limited 2 year Warranty from the Manufacturer effective from the date of purchase This fixture is warranted against defects in the quality of the housing trims diffuser shades and electrical components Fixture finishes and or lamps bulbs are expressly excluded from this warranty refer to bulb manufacturer for lam
3. p warranty This Fixture if supplied with an automatic shut off sensor motion control sensor or photocell cannot be installed in conjunction with any other device without voiding warranty Modifying this fixture or use of another non provided control will also void Product Warranty and UL listing ra gt american agg fighting association LISTED 1365 Fig 1 JUNCTION BOX WALL d SOCKET ie ALS NIPPLE KNURLED CAP PL LAMP BACKPLATE WIRE NUT CROSSBAR JUNCTION BOX SCREW PLASTIC WASHER STEEL BAR Fig 2 FIXTURE gt erxtuRE WIRES WIRES WIRES Black or WHITE OR Green or Smooth RIBBED Bare Copper Ground Co lrixture gt HOUSE HOUSE WIRES WIRES Green or White Bare Copper Neutral Ground Stud Screws Caulking Backplate
Download Pdf Manuals
Related Search