Hampton Bay 14441-028 Installation Guide
Contents
1. 7 Nipple 8 Canopy 9 Canopy Loop 10 Loop Ring INSTALLATION INSTRUCTIONS 1 Install cross bar 3 assembly complete with nipple 7 and canopy loop 9 to junction box 1 as one complete assembly N Remove loop ring 10 from canopy loop 9 Slip canopy 8 over canopy loop 9 and secure by fastening loop ring 10 Adjust the height of the nipple 7 so canopy 8 will sit flat against ceiling and tighten lock nut 6 against cross bar 3 U Remove loop ring 10 from canopy 8 from ceiling D Hold chandelier up against canopy loop 9 with chain and adjust to desired height Remove excess chain 5 Before tightening chain onto canopy loop 9 weave chandelier wire through every second link Let the canopy loop ring 10 slip to the bottom of the chain Repeat this step for canopy 8 Secure chain onto canopy loop 9 Weave wire through the canopy loop 9 and into junction box 1 oO Oo N A Install both ground wires of chandelier one from the canopy 8 and one from the fixture to ground screw 5 or ground wire of junction box 1 or ground screw 5 on cross bar 3 Ref Figure 1 10 Connect black wire of power supply to the smooth side of the wire flexible cord from the chandelier and connect white wire of power supply to the ribbed side of the wire from the chandelier Ref Figure 1 NOTE2. Always use wire nuts 2 or marrattes included to connect wires and push all excess wire and connections back into junction box 1 11 Lift canopy 8 up to ceiling covering junction box 1 and secure by using canopy loop ring 10 Page 6 TOOLS REQUIRED FOR ASSEMBLY amp INSTALLATION not included mH SS S amp S FF Safety Goggles Wire Strippers Wire Cutters Flathead Screwdriver 0 Phillips Electrical Tape Ladder B10 Bulb 60W Screwdriver not included x8 ADDITIONAL PARTS FOR ASSEMBLY included i CD 11 Chain Loop 12 Center Nut 13 Cap x2 14 Decorative Spacer W 18 Floral Bobeche 15 Top Decorative 16 Top Nipple with 17 Candle Sleeve Assembly Lock Nut 20 Decorative 21 Decorative 19 Decorative 22 Bottom Nipple Bobeche Crystal Drop Crystal A with Lock Nut 23 Decorative Finial 24 Lower Decorative Assembly Page 3 ASSEMBLY INSTRUCTIONS 1 Carefully unpack the fixture Layout all parts on a clean surface 2 Turn off power at main fuse box 3 Install bottom nipple with lock nut 22 onto the base of the fixture main body 4 Place lower decorative assembly 24 on the bottom nipple with lock nut 22 and tighten with decorative finial 23 5 Install top nipple with lock nut 16 onto the hub of the fixture main body 6 Place top decorative assembly 15 on the top nipple wi
3. TROUBLESHOOTING i al Possible Cause Corrective Action 1 Bulb is burned out 1 Replace light bulb 2 Switch is off 2 Make sure switch is on Bulb will not light 3 Faulty wire connection 3 Check wiring Crossed wires or power wire is grounding out Fuse blows or circuit breaker trips when light is turned on Check wire connections PRODUCT MAINTENANCE 1 To clean the outside of the lamp use a dry or slightly dampened clean cloth use clean water never a solvent to wipe the shade and surface of the lamp 2 To clean the inside of the fixture first disconnect power to the fixture by turning off the circuit breaker or by removing the fuse at the fuse box Next use a dry or slightly dampened clean cloth use clean water never a solvent to wipe the inside shade and interior surface of the fixture 3 Do not use any cleaners with chemicals solvents or harsh abrasives Use only a dry soft cloth to dust or wipe carefully LIMITED WARRANTY The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of five 5 years from date of purchase This warranty applies only to the original consumer purchaser and only to products used in normal use and service If this product is found to be defective the manufacturer s only obligation and your exclusive remedy is the repair or replacement of the product at the manufacturer s discretion provided that the product has not been
4. damaged through misuse abuse accident modifications alterations neglect or mishandling This warranty shall not apply to any product that is found to have been improperly installed set up or used in any way not in accordance with the instructions supplied with the product This warranty shall not apply to a failure of the product as a result of an accident misuse abuse negligence alteration or faulty installation or any other failure not relating to faulty material or workmanship This warranty shall not apply to the finish on any portion of the product such as surface and or weathering as this is considered normal wear and tear The manufacturer does not warrant and specially disclaims any warranty whether express or implied of fitness for a particular purpose other than the warranty contained herein The manufacturer specifically disclaims any liability and shall not be liable for any consequential or incidental loss or damage including but not limited to any labor expense costs involved in the replacement or repair of said product Page 8 INSTRUCTION MANUAL INTERIOR 8 LIGHT CHANDELIER ALLURE HOME DEPOT SKU 444 567 S O 451 572 UPC 773546170383 ANTIQUE SILVER FINISH Ym N A D N HANT ehas ISSA Ravin ds divin WT a VW me E7 ET Page 1 Thank you for purchasing this Hampton Bay interior decorative lighting This product has been manufactured with the highest standards of safety and
5. quality FEATURES Extravagant and sophisticated this hanging light hearkens back to glorious Hellenistic days with dangling strands of precious metal finished with leafy boughs QUESTIONS PROBLEMS MISSING PARTS Before returning to you local Home Depot please call our Customer Service Team at 1 877 527 0313 or visit www homedepot com Please reference you SKU 444 567 or UPC 773546170383 CAUTION 1 If you have any non electrical questions about this fixture please contact our Customer Service Team at 1 877 527 0313 or visit www homedepot com Please reference you SKU 444 567 or UPC 773546170383 2 Keep your receipt and these Instructions for Proof of Purchase Page 2 INSTALLATION 1 Junction Box not included Black Wire Ground Wire 2 Wire Nut x3 White Wire ire NUL 3 Cross Bar 5 Ground Screw 6 Lock Nut 4 Outlet Box Screw x2 7 Nipple 9 Canopy Loop 8 Canopy 10 Loop Ring 11 Chain Loop Be te eee oe Figure 1 pse I l FROM HOUSE FROM FIXTURE l i BLACK OR RED WIRE BLACK OR SMOOTH l FROM HOUSE FROM FIXTURE GROUND WIRE GROUND WIRE l FROM HOUSE FROM FIXTURE l Page 7 ADDITIONAL PARTS FOR INSTALLATION included S SP a O 2 Wire Nut 3 Cross Bar 4 Outlet Box 5 Ground Screw 6 Lock Nut x3 Screw x2 Ul
6. th lock nut 16 7 Insert cap 13 decorative spacer 14 and cap 13 on the top nipple with lock nut 16 oo Secure assembly by tightening center nut 12 to the top nipple with lock nut 16 9 Tighten chain loop 11 onto top nipple with lock nut 16 GLASS AND BULB INSTALLATION 1 Insert decorative bobeche 19 and floral bobeche 18 onto the fixture socket then install candle sleeve 12 2 Attach deocative crystal 21 across the base of the fixture main body 3 Place decorative crystal tear drops 20 under each socket Page 4 1 Junction Box not included ASSEMBLY 2 Wire Nut x3 Black Wire Ground Wire _ White Wire jz 3 Cross Bar a Outlet Box Screw x2 8 Canopy Loop iN 4 9 Canopy y 5 Ground Screw 6 Lock Nut 7 Nipple 10 Loop Ring 11 Chain Loop 12 Center Nut ud D 13 Cap x2 L 15 Top Decorative Assembly Vo u 17 Candle Sleeve 16 Top Nipple with l lock Nut WM 18 Floral Bobeche eere 19 Decorative Bobeche Socket 20 Decorative Crystal Tear Drop an 21 Decorative Crystal A Assembly 4 24 Lower Decorative lt gt 22 Bottom Nipple with Lock Nut 23 Decorative Finial Page 5
Download Pdf Manuals
Related Search