Sea Gull Lighting 78136-08 Installation Guide
Contents
1. exact wording from illustration when ordering parts BEFORE YOU BEGIN Carefully remove the fixture from the carton and check that all parts are included as shown in figure 1 Be careful not to misplace any of the screws or parts which are needed to install this fixture lt ioe INSTALLATION IMPORTANT DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX WITHOUT THE USE OF A MOUNTING BAR FINIAL D STEP 1 Thread fixture mounting screws BI into threaded holes of mounting bar A 3 turns each STEP 2 Secure mounting bar A to outlet box with outlet box screws not supplied Raised side is top as illustrated STEP 3 A Use a listed wire connector to connect the fixture hot wire black wire or round and smooth tracer to the supply hot wire B Use a listed wire connector to connect the fixture common wire white wire or square and rigid to the supply common wire C Gently try to remove the wires from the connector If you can remove the wires carefully re do the wiring connection FIGURE 1 NOT SUPPLIED INSTALLATION continued HC 1568 STEP 4 GROUNDING INSTRUCTIONS Connect the supply ground wire fixture ground wire and mounting bar ground wire pre attached using the supplied wiring connector Gently try to remove the wires from the connector If you can remove the wires carefully re do the wiring connection FINAL ASSEMBLY STEP 5 After wires are connected tuck them carefully inside outlet2. Installation And Safety Instructions HC 1568 Sea Gull Lighting Line art shown may not exactly match the fixture enclosed However the installation instructions do apply to this fixture Fill in Item Number on Carton and File This Sheet For Future Reference ITEM 071409 IMPORTANT SAFETY INSTRUCTIONS e Be sure the electricity to the system you are working on is turned off either the fuse removed or the circuit breaker set at off e Use of other manufacturers components will void warranty listing and create a potential safety hazard e If you are unclear as to how to proceed contact a qualified electrician e You don t need special tools to install this fixture e Be sure to follow the steps in the order given ene e Read instructions carefully e Save these instructions A E MOUNTING BAR A NOTE FOR FIXTURES PROVIDED WITH 75 C OR 90 C SUPPLY WIRE FOUND ON CARTON LABEL WARNING ONLY RISK OF FIRE MOST FIXTURE MOUNTING WELLINGS BUILT BEFORE 1985 HAVE SUPPLY WIRE RATED 60 C SCREWS B CONSULT A QUALIFIED ELECTRICIAN BEFORE INSTALLING G GROUNDING CLEANING a To clean wipe fixture with a soft cloth Clean glass with a mild soap Do not use abrasive materials such as scouring pads or powders steel wool or abrasive paper ORDERING PARTS Keep this sheet for future reference and in case you need to order replacement parts Parts for this fixture can be ordered from place of purchase Be sure to use
3. box Raise the canopy E to the ceiling allowing for mounting screws B to protrude through key slots C Rotate canopy E clockwise until screws B are in narrow part of keyslot C Tighten mounting screws B with screwdriver STEP 6 Install lamps STEP 7 Raise diffuser H to canopy so that center pipe G protrudes through diffuser H Secure in place by threading finial D to center pipe G
Download Pdf Manuals
Related Search