Swanstone US01513SB.015 Installation Guide
Contents
1. careful that the overhang is uniform and aligned to the cut out 5 Cut 3 wide strips of 3 4 thick plywood and trial fit around the perimeter of the Swanstone kitchen sink except where faucet holes will be located It is suggested that a 1 4 space exist between the plywood strips and the sink flange The Swan Corporation One City Centre at 6 Join the plywood strips to the countertop surface with contact cement 10 Lightly tighten screws so sink position can be verified Suite 2300 e Denatured alcohol e 3 4 plywood cut to 3 wide strips e Plywood or Masonite material to fabricate a sink template SWANSTONE SINK CLIP PLYWOOD STRIPS CONNECTED TO COUNTERTOP WITH CONTACT CEMENT COUNTERBORE APPROX 1 4 OVERHANG VARIES BY PREFERENCE LOCATE 3 4 X 3 WIDE PLYWOOD STRIPS AROUND PERIMETER OF SWANSTONE KITCHEN SINK COVER AS MUCH OF PERIMETER AS POSSIBLE 100 SILICONE SEALANT RATA LW Tk dE WD Lil rm w aiy Ree TE DO NOT COVER FAUCET LOCATION WITH PLYWOOD STRIPS 7 Remove the Swanstone sink and clean both the countertop and sink flange with denatured alcohol 8 Apply a continuous bead of 100 percent silicone around the sink flange and set the sink into place St Louis MO 63101 p 800 325 7008 UNDER MOUNT OVER LAP 9 Using the sink clamps and screws provided by Swan 1P3115 10 secur2. 33111_DA_ Swan 9 20 10 11 06 AM Page 1 OCOE SN SLOE SN LECOC SAN TOP 0081 SN w SWANSTONE Strength Balance Beauty RECOMMENDED UNDERMOUNT OVERLAP INSTALLATION OF A SWANSTONE SOLID SURFACE KITCHEN SINK The Swan Corporation will not be liable for damage of the coun Supplied by Swan tertop during or after installation Prior to installation inspect e Kitchen sink all product for damage Do not install damaged material or the e Sink clips and screws warranty will be null and void Material Required A Swanstone kitchen sink can be mechanically mounted to a e 100 silicone countertop surface other than Swanstone with 100 silicone e Mineral spirits adhesive only Mounting the Swanstone solid surface kitchen e Contact cement sink to any solid surface other than Swanstone with a hard seam will void the Swanstone warranty Working from the top of the countertop 1 Select the bowl template that applies to the installation that you desire Cut out the inside of the template 2 Position the template onto countertop the desired location Sink position will be determined by cabinet size cabinet supporting members and deck mounted fittings 3 Cut sink hole into countertop per manufac turers recommendations Finish sink hole as desired with tools compatible with the manu facturer of the countertop Working from the bottom of the countertop 4 Set the kitchen sink into position being
3. e the Swanstone kitchen sink into place A sink clip should be positioned everywhere there is a counterbore located on the sink flange 11 Tighten screws securely If desired additional temporary clamps not provided can be used to pull the sink flange tightly to counter 12 Use mineral spirits and a soft cloth to remove excess silicone that has been squeezed out by the mounting procedure Be sure that there is a consistent seal along the interior perimeter of the sink f 314 231 8165 FORM IN2 02 10 1M TOP US 1800 US 2021 US 3020
Download Pdf Manuals
Related Search