Vox 073022 Instructions / Assembly
Contents
1. to follow this instruction will void warranty e Refer to engine operator s manual and follow oil and fuel recommendations and instructions NOTICE Check oil often during engine break in Refer to engine operator s manual for recommendations Attach Suction Hose You will need the following tool to install the hoses to the trash pump e 1 4 or 6mm standard screwdriver Connect Suction Hose to Pump The suction hose must be reinforced with a non collapsible wall or braided material DO NOT use a hose with an inside diameter smaller than the pumps suction port size 1 Slide barb cuff A over hose barb B Insert rubber seal C into end of barb cuff 2 Screw hose barb assembly onto pump in clockwise rotation until hose barb assembly is tightened securely 3 Slide hose clamp A over end of hose B Slide Connect Discharge Hose Optional suction hose onto hose barb C Tighten hose clamp securely using a standard 1 4 6mm screwdriver If desired use a commercially available hose DO NOT use a hose with an inside diameter smaller than the pump s discharge port size 1 Slide barb cuff over hose barb Insert rubber seal into end of barb cuff as shown earlier 2 Screw hose barb assembly onto pump in clockwise rotation until hose barb assembly is tightened securely Attach Suction Hose to Strainer Basket Slide hose clamp over hose Attach open end of suction hose to strainer hose barb Tighten hose clamp se2. Assembly LO Read entire operator s manual before you attempt L to assemble or operate your new trash pump Your trash pump requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel If you have any problems with the assembly of your trash pump please call the trash pump helpline at 800 743 4115 If calling for assistance please have the model revision and serial number from the identification label available See Controls section for identification label location The following is representative of a typical installation using typical components and should be used as a guide when setting up your pump Be sure to use a reinforced inlet hose that will not collapse when in use Also use 2 inch NPT connections at the inlet and outlet ports To prepare your trash pump for operation you will need to perform these tasks 1 Add oil to engine crankcase Add fuel to fuel tank Attach suction hose Connect discharge hose optional Move trash pump to safe operating location Prime the trash pump 7 Locate strainer basket into water source Add Engine Oil and Fuel e Place trash pump on a flat level surface aoa Ww Pp NOTICE Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in equipment failure e Refer to engine manual for oil and fuel fill information e Damage to equipment resulting from failure
3. curely using a standard 1 4 6mm screwdriver 3 Slide hose clamp over end of discharge hose Slide discharge hose onto hose barb Tighten hose clamp securely using a standard 1 4 6mm screwdriver 8 BRIGGSandSTRATTON COM
Download Pdf Manuals
Related Search