Racor PBH-1R Instructions / Assembly
Contents
1. acor HOME STORAGE PRODUCTS BIKE LIFT PBH 1R INSTRUCTIONS WWW RACORSTORAGESOLUTIONS COM TOOLS REQUIRED PARTS LIST ee Phillips driver Phillips driv BOR Back lift Assembly A amp S xI 48 foot 14 6m rope ezzzzze 1 3 Drill bit x6 2 5 cm wood screws Drill Front lift Assembly x1 Rope Cleat Tape Measure Hook Pulleys WARNING Please read installation instructions carefully prior to installing Before using the product thoroughly test the fully weighted product with equipment in place to ensure the product has been installed properly Do not allow children to play on product ITW Brands is not responsible for any damage resulting from improper installation overloading or product failure O Measure the distance between the Use two wood screws each to Feed rope through square hole on handle bars and seat of the bike mount the back pulley and the the back lift assembly Tie a double Mark that distance on ceiling front pulley to the ceiling ensuring knot as shown The knotted end joist s the distance between the two will be between joist ceiling and matches the measurement made in lift assembly step 1 Predrilling 1 8 in pilot holes in the ceiling will make mounting the pulleys easier O Thread the rope through the pulleys as shown2. OVERHEAD WARNING 5 Thread the rope down though both O Use 2 wood screws to mount the parts of the locking mechanism rope cleat to the wall When the bike is up to the ceiling the excess rope should be stored in the cleat Make sure that there are no obstructions to restrict operation of the bike lift e g cars equipment garage doors misc items etc USING THE BIKE LIFT Hook the bike handlebar and seat with the hooks and be sure the ropes are not twisted The bike can now be raised to the ceiling by the pulling rope The rope will lock in place with each pull preventing the bike from falling For safety tie the rope on the cleat and wind the excess rope around it DO NOT CUT THE ROPE Limited Warranty These products are sold as is without any express or implied warranties ITW Brands sole liability if any shall be to replace this product or refund the purchase price The performance of these products is subject to variable conditions and maximum load ratings are shown for comparison purposes only PBH 1R Made in China ITW Brands A division of Illinois Tool Works Inc 955 National Parkway Suite 95500 Schaumburg IL 60173 800 783 7725 www RacorStorageSolutions com Email racorcs itwbrands com 2011 Illinois Tool Works Inc Racor and Racor logo are registered trademarks of Illinois Tool Works Inc LOWERING THE BIKE Pull the rope towards the back lift ass
3. embly maintaining tension on rope The tension will keep the locking mechanism open and the bike will be able to lower Slowly let the rope out as the bike lowers Once the bike is low enough remove it from the hooks and tie the rope back to the cleat roacor HOME STORAGE PRODUCTS Thank you for purchasing this product Racor storage and organizational solutions will inspire and put you back in control of your space Racor has the largest variety of solutions to organize and store bikes sports equipment lawn and garden supplies bulky items like ladders and totes and clutter items like tools Please visit www RacorStorageSolutions com for other great organizational products
Download Pdf Manuals
Related Search