Speakman SA-1302 Instructions / Assembly
Contents
1. Drill 1 4 hole in marked locations If drilling into tile be sure to use a drill bit designated for tile If mounting directly into stud or wood wall secure lower end bracket to wall with mounting screws without drilling holes FIR ER Insert Plastic Anchors into drilled holes and press in until flush with wall Secure Mounting Brackets to wall with Mounting Screws using Phillips screwdriver Instal Slide Bar assembly over Mounting Bracket and secure with Set Screws using small Flathead Screwdriver RPGO5 0893 ism 8 32 UNC 2A THREAD SET SCREW2. Instructions for Models SA 1302 Need Help For additional assistance or service call SPEAKMAN Company 400 Anchor Mill Road New Castle DE 19720 PHONE 800 537 2107 EMAIL customerservice speakmancompany com WEB www speakmancompany com 92 333 1 R2 What You Need To Know Tools Required Phillips Screwdriver Pencil Drill with 1 4 Bit Small Flathead Screwdriver Helpful 1 4 Tile Drill Bit Level Important Notes Be sure to read instructions thoroughly before beginning installation Do not overtighten any connections or damage may occur Safety Tips This item is NOT designed for use as a grab bar Do not mount in locations where product is likely to be used as a grab bar Use caution when drilling into walls to avoid electrical and plumbing lines hidden within wall Maintenance Clean with a soft damp cloth only Do not use scrub pads detergents or cleansers as they may harm the protective finish of your Slide Bar and remove Mounting Brackets from both ends Loosen Set Screws with small Flathead Screwdriver of Slide Bar assembly Place Slide Bar assembly on to wall in the desired mounting position Take care that the Slide Bar is oriented in a vertical position Using a pencil lightly trace outline of end brackets on to wall Center Mounting Bracket within traced outline Mark the 2 mounting locations with a pencil Mounting Bracket
Download Pdf Manuals
Related Search