Builders Edge 060010637002 Installation Guide
Contents
1. Step 7 Center the Keystone Base over the Window Header Assembly The tab at the bottom of the Keystone Base is to aid in installation The bottom of the tab and the bottom of the Window Header should be flush Screw the Keystone Base into place using the enclosed screws See Figure 7 at right Note Shutter Loks may be used to secure the Keystone Base to the Window Header If Shutter Loks are being used drill two 1 4 holes through the Window Header and Tray to accept the Shutter Loks See Figure 8 at right Step 8 Snap the Keystone over the Keystone Base Be sure the lock tabs engage See Figure 9 at right F Drill and place Shutter Loks in these locations __ Fig 8 mmy lie m a P SLE Fig 92. 6 Window Header Keystone Installation amp Cutting Instructions Kit Contains 1 pc Keystone 1 pc Keystone Base 4 pcs Screws Keystone Base Keystone NOTE IF HEADER IS NOT BEING CUT PROCEED TO STEP 7 IF HEADER ARRIVED IN 2 PIECES PROCEED TO STEP 4 Step 1 Measure the width of the window across the largest Draw horizontal line 1 8 i above window trim measurement to create Dim A Also draw a horizontal line 1 8 above the window trim This line will be used to properly space the Window Header from the window trim See Figure 1 at right Fig 1 Step 2A If your window doesn t match the exact size of the G Window Header and Base Window Header right from the box the Window Header ere ree will need to be cut With the Window Header and Window Header Base assembled mark the center on the assembly See Figure 2A at right Dim B m Fig 2A Step 2B Next subtract Dim A from Dim B and divide the measurement by 2 This will give you Dim C See Dim B Dim A OE Figure 2B at right a S Dim C Fig 2B Step 2C Transfer Dim C to the Window Header Assembly Dim C will be transferred 2 times once on each side of the centerline See Figure 2C at right Fig 2C 01 24 01 PAPC9165 1 0054 Step 3 Cut the Window Header and Window Header Base assembly at the lines created by Dim C See Figure 3
3. at right Step 4 Once the Window Header has been cut to the correct length disengage the locking tabs and remove the Window Header from the Window Header Base To release the locks start at the open end of the cut Header Assembly and pull the wall of the Header away from the Header Base Continue this process working your way to the end of the cut Window Header Assembly See Figure 4 at right Step 5 Align the bottom of the Window Header Base to the line drawn 1 8 above the window trim Mate the two cut ends of the Window Header Base to each other The preferred method of attaching the Window Header Base to the house is to use the Shutter Loks that are enclosed with the Window Header Kit In order to install the Shutter Loks 1 4 holes must be drilled into the wall to accept the Shutter Loks Another method is to use screws Use the elongated slots in the Header Base and attach the tray to the house using the screws provided with the Window Header Kit Be sure not to fasten the screws too tightly to allow for expansion and contraction See Figure 5 at right Step 6 With the Window Header Bases securely fastened to the wall the Window Header can be snapped into place by engaging the locks See Figure 6 at right Line created from Dim C Remove shaded area Line created from Dim C slots for optional screw application
Download Pdf Manuals
Related Search