House of Fara P350MDF Installation Guide
Contents
1. How to Install Doorway Trim To install doorway trim you will need a power drill and 3 32 inch drill bit a hammer and 2 inch finishing nails a hand and or power saw putty or wood filler a pencil measuring tape and safety glasses Right A Make a mark approximately 1 8 inch above top left corner of door jamb B Measure distance from top of plinth block 1 to mark Cut both left and right fluted pieces 2 6 to this measurement see installation instructions for plinth blocks on other side C Pre drill 3 32 holes in both side fluted pieces 2 6 to prevent nails from splitting wood D Center both fluted pieces 2 6 on top of plinth blocks 1 7 Make sure fluted pieces are parallel to jamb edge Nail both pieces in place using 2 nails E Center both rosette blocks 3 5 on tops of side fluted pieces 2 6 Cut top fluted piece 4 to this length G Pre drill nail holes in both rosette blocks and top fluted piece H Center left rosette 3 on top of the left side fluted piece 2 and nail in place J Push right rosette tight against both fluted pieces Nail in place K Fill nail holes and any gaps with putty or wood filler of matching color use smallest amount possible for a neat job Then carefully touch up with paint or stain only where necessary
Download Pdf Manuals
Related Search