OWT Ornamental Wood Ties 56612 Use and Care Manual
Contents
1. Post lo Beam 2 Laredo Sunset Item 56610 Replacement Parts Kit Includes 2 Post Ledge Base a 8 Hex Cap Nuts c 2 Top Cover Plates b 4 3 Lag Bolts d 4 2 Lag Bolts e e 2 piece design allows the base to be mounted before beam is positioned e Accommodates beams up to 1 7 8 thick without dado 4 thick beams require 2 dado e Includes hardware for attaching beam to post for standard 2 installations e 3 16 thick steel base amp decorative plates www OZCOBuildingProducts com patent pending Post 0 Beam 2 nss Laredo Sunset Installation Guide General Guidelines e Materials are heavy and bulky minimum of 2 people are required for most installations e Brace and tie off large beams and posts until all connections are made e Wear proper safety equipment e Check with local authorities and home owners association before construction e Check for underground and or hidden utilities that could be damaged e Be sure to use the right tool for the job e Plan ahead and have the required hardware fasteners and tools close at hand before starting the installation Steps 1 Measure and mark the post at the location where the BOTTOM edge of the beam will be 2 If adding an accent medallion drill all holes in the decorative plates using 3 160 drill bit Locate tip of drill bit on dimple 3 Remove threaded covers from all Hex Cap Nuts a Insert Lag Bolts into Cap Nuts b OWT Lag Bolts require a 3 8 Hex Bit2. c Replace Threaded Covers until flush with edge of the nut d HINT Use tread lock on Threaded Covers in accessible areas 4 Attach angled base to post with the shorter lag screws assuring that it is mounted level 5 Rest beam on Angle Base and position the Cover Plate so the tabs on the Angle Base engage with the Cover Plate a If attaching 4 beam to post you must dado the post 2 with saw b WARNING lag screws provided with the 2 Post to Beam kit are not long enough for 4 installations 6 Attach Cover Plate with lag bolts 7 Install Decorative Medallion Use and Care This hardware may not be suitable for every situation or installation application A design professional should be consulted to ensure the specific installation application meets local building code requirements If hardware becomes dirty clean with soap and water Avoid abrasions to surface and touch up any scrapes with paint Rinse with fresh water if hardware comes in contact with ice salt or salt water Sau 07 60 BUILDING PRODUCTS EE EH m www OZCOBuildingProducts com 2012 OZCO Building Products All Rights Reserved Design and Marketing by LiquidFly Designs
Download Pdf Manuals
Related Search