Phillips Manufacturing Company CAP135 Instructions / Assembly
Contents
1. te HILLIP 9 ae Recommendations MANUFACTURING CO Engineered to Perform gripSTIK Vinyl 3 Way 3 4 Bullnose Splay Corner Caps Installation Recommendations Phillips recommends installation in accordance with applicable ASTM standards and using prevalent industry standards General Installation Guidelines Phillips gripSTIK vinyl 3 4 3 way bullnose splay corner caps are designed to finish where 2 Outside 3 4 Bullnose Corners and 1 Outside 3 4 Bullnose tf Outside Splay Corner intersect and can be installed using a variety of methods The h Outside method listed below is a guideline 90 90 Method Spray Adhesive gripSTIK Spray Adhesive Recommended 1 For 3 4 radius bullnose corner beads and corner caps installation drywall must be set back so it does not interfere with bullnose radius 2 The installation of gripSTIK vinyl 3 4 3 way bullnose splay corner caps Splay Drawing must occur before the installation of the 3 4 bullnose corner bead and 3 4 Not to Scale bullnose splay corner beads 3 Puta coat of spray adhesive on the back of the corner cap a Immediately apply cap to drywall and position in place b If the adhesive dries too long it will be hard to reposition c At some point the adhesive will lose tackiness and will not bond If this happens reapply adhesive to cap 4 The rate at which the adhesive dries varies depending on heat and humidity Test in your conditions 5 Use handle of your2. taping knife or installation tool to apply pressure along mud flanges perforated sections Bond strength is greatly enhanced with this crucial step 6 Staple each mud flange perforated sections with several 1 2 crown staples 7 Pressure the mud flanges again see step 5 8 Install 3 4 bullnose corner bead following corner bead installation instructions 9 No primer is needed Finish as usual 10 For cold weather winter applications please refer to the installation recommendations in the Gypsum Association GA 220 06 of 40 F or warmer With Phillips gripSTIK vinyl beads trims and corner caps No mud additives needed No primer needed Made in the U S A Phillips is proud that all our beads trims and accessories are made in the United States of America 2012 Phillips Manufacturing Company p Version 1 0 Page 1 of 1 PHILLIPSmrc com
Download Pdf Manuals
Related Search