Phillips Manufacturing Company ICBVYL Instructions / Assembly
Contents
1. te HILLIP 9 Installation Recommendations MANUFACTURING CO Engineered to Perform C Sips gripSTIK Vinyl Inside Corner Adjustable Beads Installation Recommendations Phillips recommends installation in accordance with applicable ASTM standards and using prevalent industry standards General Installation Guidelines Phillips gripSTIK vinyl Inside Corner Adjustable beads can be installed using a variety of methods The methods listed below are guidelines Phillips recommends you test which method works best for you Some vinyl products require more detailed installation instructions than are listed here Method 1 Stapling 1 For Inside Corner Adjustable drywall does not need to be set back 2 For special lengths cut the bead to length and dry fit a Prevent overlap of the mud flanges by snipping back b Dry fit the bead Staple each mud flange every 6 10 with 1 2 crown staples No primer is needed Finish as usual For cold weather winter applications please refer to the installation recommendations in the Gypsum Association GA 220 06 of 40 F or warmer g e w Method 2 Spray Adhesive gripSTIK Spray Adhesive Recommended oh Follow steps 1 and 2 above 2 Put a coat of spray adhesive on the back of the bead and then on the drywall a Immediately apply bead to drywall and position in place b If the adhesive dries too long it will be hard to reposition c At some point the adhesive will lose tacki2. ness and will not bond If this happens reapply adhesive to both surfaces 3 The rate at which the adhesive dries varies depending on heat and humidity Test in your conditions Use handle of your taping knife or installation tool to apply pressure along both mud flanges Bond strength is greatly enhanced with this crucial step Staple mud flanges to assist bonding between bead and wallboard with 1 2 crown staples Pressure the mud flanges again see step 4 No primer is needed Finish as usual For cold weather winter applications please refer to the installation recommendations in the Gypsum Association GA 220 06 of 50 F or warmer iN o Ng With Phillips gripSTIK vinyl beads and trims No mud additives needed No primer needed Made in the U S A Phillips is proud that all our beads trims and accessories are made in the United States of America 2012 Phillips Manufacturing Company p Version 1 0 Page 1 of 1 PHILLIPSmrc com
Download Pdf Manuals
Related Search