The Cement Store Black Label High Gloss Installation Guide
Contents
1. or if applying over On vertical surfaces apply sealer from the bottom up to prevent unevenness from runs SOLVENT BASED sealer The basic rule for time between coats is 24 hours You will be able to walk on it within 2 hours and drive on it with 24 48 hours 2 Use TCS OILOUT oil spot remover as per directions if necessary i a 7 A enD S egal a ae surface will be slippery when wet 3 Use TCS PINKPREP cleaner degreaser as per directions OF AECEC SAIE yip ease se ant SIR ANNE 4 Rinse entire area that is being sealed and give ample time 24hours gt Can add tint if necessary 1 Surface must be clean and free of dirt debris oil and contaminants to dry before applying new sealer HIGHLY FLAMMABLE 5 Repair any scratches peeling white marks or blushing with RED Refrain from smoking when using the product Use an efficient extractor fan if the product is LABEL WHITEOUT as per directions applied in an enclosed area Vapors may form an explosive mixture in the air CLEAN UP Use a solvent like RED LABEL WHITEOUT to clean tools aT r Keep container tightly closed when not in use Keep away from heat from open flame See our website for TIPS and further information Keep out of reach of children Do not freeze COVERAGE O O memes blacklabelsealer com mamm i Approx 125 200 sq ft per gallon Coverage varies due to porosity and condition of concrete surface PRODUCT OF CANADA 18 9 L 5 Gallon RESIN SOLUTION flammable Cla2. DIRECTIONS FOR USE Apply BLACK LABEL HIGH GLOSS as a finish or top coat on fully cured concrete after 28 days which has been previously sealed with BLUE LABEL CURE amp SEAL Will darken surface ollow SURFACE PREPARATION steps o not apply in wet weather or if rain is expected in 24 hours he product supplied is formulated at the consistency for application DO NOT DILUTE Any dilution will reduce the performance and gloss horoughly mix before applying O NOT apply in DIRECT SUNLIGHT see YouTube videos Apply product on a dry surface when air and surface temperatures are between 5 C 30 C and will remain between 5 C 30 C for at least 4 hours after applying WHAT TYPE OF SEALER WAS APPLIED BEFORE Use a solvent resistant poly wool roller with a nap to match the surface being protected or use a rofessional sprayer If WATER BASED sealer has been applied at any time in the past it must be completely removed before applying ANY new sealer DONOT pour directly from container onto surface Always use a tray amp a solvent resistant tray liner RED LABEL WHITEOUT will remove old sealer Do not run a roller dry do sections small enough to maintain a wet edge Some areas may be more porous than others and may require additional coats to even out final SURFACE PREPARATION appearance and provide extra protection Sealer should not be allowed to puddle or run Once WATER BASED sealer has been removed
3. ss 3 UN 1866 PGII
Download Pdf Manuals
Related Search