Wagner 0530000 Installation Guide
Contents
1. IMPORTANT This unit is intended for use with water based latex materials only DO NOT use this unit with any flammable or oil based materials Latex paints can be cleaned with soapy lukewarm water DO NOT use hot water when cleaning or flushing the unit Filling the Paint Tube 1 Remove the trigger housing a from the paint tube b by turning it 1 4 turn figure 1 2 Attach the fill adapter c to the paint tube Once the threads engage it will be secured after approximately 1 4 turn figure 1 3 Dip the end of the fill adapter into the material you plan to roll It is unnecessary to dip the fill adapter any further than the fill line d as shown figure 1 4 With the end of the fill adapter in the paint pull back on the handle e to fill the paint tube figure 2 5 Carefully remove the fill adapter by turning it 1 4 turn Once it is removed hook it to the side of the paint container Figure 1 IMPORTANT When removing any items from the fill adapter some paint may drip Make sure your floors and furnishings are protected by drop cloths 6 Attach the trigger housing back onto the paint tube Once the threads engage it will be secured after approximately 1 4 turn Rolling 1 To deliver paint to the roller pump the trigger several times until you see paint coming through the roller cover 2 You are now ready to begin rolling Pump the trigger as needed to bring paint to the roller 3 Refill the pain2. t tube as needed by repeating the steps above Note The roller arm assembly can hang from the side of the paint container when refilling figure 2 Rolling Tips figure 3 In order to more quickly saturate the trim brush with paint roll paint on the surface and then touch the brush into the paint The trim brush f can be swiveled into different positions depending upon the position of the edge being rolled against Always make sure the trim brush is facing toward and running parallel to the surface being painted Maintain a consistent rolling angle to ensure the trim brush maintains contact with the surface Contact will be maintained as long as the edge of In order for the trim brush to fully cover the the guard g stays flat to the surface gap you will need to move the roller ina For particularly tight corners i e where two walls gentle up and down brushing motion meet you may need to go back and fill any gaps much like you would do with a regular paint with a brush brush Periodically inspect the outer face of the roller The guard can be fully opened and locked guard for any paint residue Make sure the outer out of the way when not rolling up against face of the roller guard stays clean an edge N Wagner Spray Tech All Rights Reserved
Download Pdf Manuals
Related Search