Rust-Oleum Automotive 248917 Use and Care Manual
Contents
1. AUTOMOTIVE DESCRIPTION AND USES Rust Oleum Truck Bed Coating Applicator Kit is designed for use with Rust Oleum Truck Bed Coating It is important to have a clean surface for maximum adhesion Kit includes a scuff pad brush roller pan and roller frame and cover NOTE This product may not adhere over repainted or refinished surfaces or silicone based sealants When coating repainted surfaces it is recommended to test product in an inconspicuous area to ensure product does not lift or damage finish If lifting occurs allow to dry then strip and sand the area to bare metal NOTE If the existing finish has been coated with a silicone based car sealant the entire surface must be thoroughly cleaned and sanded to remove all silicone residue to allow product to adhere to truck bed surface PRODUCTS SKU Description 248917 Applicator Kit PRODUCT APPLICATION SURFACE PREPARATION Remove dirt grease wax rust and loose paint from the surface Wash the truck bed with warm water and an ammonia based cleaner Rinse and dry thoroughly Wipe down the truck bed with Rust Oleum Wax amp Tar Remover sold separately Mask the entire area that will not be coated to protect adjacent areas from paint splatter or over spray Using the enclosed scuff pad thoroughly scuff sand the entire truck bed surface Remove sanding dust with a vacuum tack cloth or by using a small amount of Wax amp Tar Remover on a clean cloth and wiping the entire2. truck bed __ TECHNICAL DATA ATO 75 TRUCK BED COATING APPLICATOR KIT PRODUCT APPLICATION cont APPLICATION Truck Bed Coating can be used directly on properly prepared surfaces No primer is needed on bare metal surfaces Prepare Truck Bed Coating as directed on the gallon or quart label Place the roller pan on a flat surface and pour a small amount of product into the pan Start by trimming the edges and corners with the enclosed brush This can also be achieved using a can of Rust Oleum Truck Bed Coating Aerosol Start at the front of the truck bed and work backward toward the tailgate With the enclosed roller spread a thin amount of product evenly over the entire truck bed surface The first coat will dry in 1 2 hours Important Place roller cover in a plastic bag and out of direct sunlight to keep the cover from drying out Do not leave the roller in the pan between coats Before the second coat is applied test the coated surface to ensure the coating has dried enough in order to re enter the truck bed Apply a second coat to the entire surface Make sure to cover all missed to thinly coated areas Allow the coating to dry 24 hours before using the truck bed Additional coats can be applied to build up thickness and increase the surface texture as desired The technical data and suggestions for use contained herein are correct to the best of our knowledge and offered in good faith The statements of this literatu
3. re do not constitute a warranty express or implied as to the performance of these products As conditions and use of our materials are beyond our control we can guarantee these products only to conform to our standards of quality and our liability if any will be limited to replacement of defective materials All technical information is subject to change without notice Rust Oleum Corporation 11 Hawthorn Parkway Vernon Hills Illinois 60061 An RPM Company ge RUST OLEUM BRANDS Form GDH 202 Phone 877 385 8155 Rev 102413 www rustoleum com
Download Pdf Manuals
Related Search