Zinsser 62008 Use and Care Manual
Contents
1. contact with the surface of embossed or delicate wallcovering Book and hang wallcovering according to the manufacturer s instructions COVERAGE Spread rate may differ with various wallcoverings DRY TIME Drying time will vary depending on the wallcovering type temperature ventilation and humidity in the room CLEAN UP Remove excess adhesive on or around the wallcovering immediately with clean water Additional effort may be required if adhesive is allowed to contact the surface of embossed or textured vinyl Close container tightly after each use TOOL CLEAN UP Clean tools with warm water STORAGE Protect from freezing Always keep the container tightly closed and store in a cool dry place at temperatures between 40 100 F 4 38 C 2 Form GDH 131 Rev 080113 ZINSSER TECHNICAL DATA SUREGRIP ALL PURPOSE ADHESIVE amp WALL SIZE PHYSICAL PROPERTIES All Purpose Adhesive amp Wall Size when mixed with water Resin Type Starch based Adhesive Solvents Water Appearance Clear Odor Mild Solids by Weight 100 Volatile Organic Compounds lt 10 g l 0 083 Ibs gal Practical Coverage at Recommended DFT assumes 15 material loss Coverage depends on the surface conditions and thickness of application Dry Times at 70 80 F 21 27 C and 50 Relative Humidity Drying time will vary depending on the wallcovering type temperature ventilation and humidity in the2. This product is not intended for hanging wallcoverings over existing vinyl wallcoverings without the use of a primer For hanging directly over vinyl without priming use SureGrip 127 Vinyl over Vinyl Wallcovering Adhesive according to label directions For hanging lightweight wallpaper or borders directly over unprimed vinyl use SureGrip Universal Adhesive or SureGrip Border Adhesive for Wallpapered Surfaces Textile Delicate Polyolefin Polyester Backed Wallcoverings Take special care to keep the adhesive off the face of textile or delicate wallcovering Some wallcovering can be stained by water alone Test for stain resistance prior to installation and hang according to manufacturer s instructions Form GDH 132 Rev 080113 TECHNICAL DATA ZINSSER MAU 11 1 N rel 0 ch on PRODUCT APPLICATION cont MIXING In a clean container slowly mix the contents of carton with water as recommended on the carton Stir until product is completely dissolved Wait ten minutes before using stirring occasionally Mix only the amount intended for use Do not store unused mixed material APPLICATION Use only when temperature is between 50 100 F 10 38 C and the relative humidity is less than 85 Apply adhesive to the back of wallcovering with a brush roller or pasting machine Smooth the adhesive evenly over the entire wallcovering Make sure sufficient adhesive is on edges Make sure sufficient adhesive is on edges Avoid
3. room Shelf Life 2 years Flammability Non flammable Safety For additional information see MSDS NOTE Calculated values may vary slightly from the actual manufactured material The technical data and suggestions for use contained herein are correct to the best of our knowledge and offered in good faith The statements of this literature do not constitute a warranty express or implied as to the performance of these products As conditions and use of our materials are beyond our control we can guarantee these products only to conform to our standards of quality and our liability if any will be limited to replacement of defective materials All technical information is subject to change without notice ma RUSTOLEUM BRANDS Rust Oleum Corporation 11 Hawthorn Parkway Vernon Hills Illinois 60061 An RPM Company Form GDH 131 Phone 877 385 8155 Rev 080113 www rustoleum com
4. pF TECHNICAL DATA SUG 06 ZINSSER QUALITY SINCE 1849 DESCRIPTION AND USES Rust Oleum SureGrip All Purpose Adhesive amp Wall Size is a high performance powder adhesive for hanging all types of pre pasted and non pasted wallcoverings and borders This adhesive is suitable for use with special and delicate wallpapers non woven coverings and fabrics It readily dissolves in cold water without forming lumps spreads easily dries clear and is odorless This all purpose adhesive is strippable and makes positioning easier This product is an excellent wall size for preparing walls prior to the application of wallcoverings It enhances bonding and allows for easy stripping later SureGrip All Purpose Adhesive amp Wall Size is not intended for hanging borders or wallcoverings over existing vinyl wallcovering without the use of a primer See Existing Vinyl Wallcovering under Application in next column for recommendations SureGrip All Purpose Adhesive amp Wall Size is not recommended for hanging heavy type II or Il commercial wallcoverings PERFORMANCE CHARACTERISTICS e Non staining powder adhesive e Ideal for murals grass cloth string and fabric e Excellent for preparing wall surface prior to hanging making positioning easier e Easy to mix dries clear PRODUCTS SKU Container Size 62008 8 ounces PRODUCT APPLICATION SURFACE PREPARATION Surfaces must be clean dry sound and free of dust grease wa
5. x oil old wallcovering adhesive mold and mildew and other residue Inspect the surface for paint bonding loose wallcoverings damaged wallboard or plaster Remove old or loose wallcovering and residual wallcovering adhesive with DIF Wallpaper Stripper Repair unsound surfaces Seal loose paint or damaged drywall and cured skim coats with Gardz High Performance Sealer as needed SUREGRIP ALL PURPOSE ADHESIVE amp WALL SIZE PRODUCT APPLICATION cont Mold amp Mildew Eliminate pre existing mold and mildew by washing the affected area with a solution of 3 4 cup of bleach to 1 gallon of water Wear protection to prevent skin and eye contact Quickly wash off any solution that comes in contact with your skin Do not add ammonia or other cleaning agents to the bleach solution Rinse surface with clean water Allow surface to dry thoroughly before applying wallcovering Drywall Wipe down with a damp cloth to remove residual joint compound dust prior to priming Plaster New plaster must age at least 90 days before hanging wallcovering Prime prior to installation Glossy Surfaces Glossy paint paneling metal glass plastic etc should be primed with ShieldZ Universal ShieldZ Universal Plus ShieldZ Clear Acrylic Wall Size or ShieldZ Oil Base Wallcovering Primer prior to wallcovering installation Metal surfaces should be primed with rust inhibiting Bulls Eye 1 2 3 Primer Existing Vinyl Wallcovering
Download Pdf Manuals
Related Search