Alsa Refinish KC-CRZS-BS Instructions / Assembly
Contents
1. 8 Rinse with fresh water and allow to completely dry 9 Remove any existing loose paint or rust etc with a wire brush or sand paper 10 Lightly sand glossy surfaces to create a surface profile for adhesion 11 Apply your primer to the surface according to the manufacturers specifications for your particular primer 12 Let your primer cure according to the manufacturers specifications for your particular primer and then lightly scuff that to create a surface profile for adhesion 13 Now apply your Alsa base coat or any good urethane base coat according to the manufacturers specifications for your base coat 14 If a second coat is required let the first coat flash for about 10 15 minutes and then apply your second coat over that again making sure to use steady even passes 15 Let your base coat flash for about 10 15 minutes and now you are ready to apply your Crazer paint 16 Apply a wet coat of the Crazer paint over your existing base color and immediately WP wrap in plastic wrap The more you wrinkle the plastic wrap the more dramatic the effect will be Removing the plastic wrap right away after texturing will allow the Crazer paint to flow back out a little bit and give you softer edges to the pattern Letting the Crazer dry completely about 30 45 minutes and then removing the plastic wrap will give you very distinct sharp edges to the pattern 17 Other patterns Crazer paint can also be textured using othe2. al SB rinish APPLICATION GUIDE CRAZERS KILLER CAN How to Apply Application Steps 1 Crazer Paint is applied over an existing base coat of any color Such as Alsa s Base Pearls or Alsa s Stylin s base coats with black being the most popular and then marbleized using plastic wrap as a texturing tool to create the marbling effect Standard plastic wrap such as Saran Wrap is all you need for this effect You can also use any number of things to create a texture Brushes sponges anything that will leave a pattern behind in the wet Crazer paint This is your time to experiment If you piece already has a base coat on it you can proceed to step 14 Always apply paints in a well ventilated area and wear a NIOSH approved respirator to avoid breathing any fumes 5 Make sure you have good conditions for spraying The best temperature for spraying this paint is 75 80 degrees F and VERY low humidity 6 Prepare and prime your part first Epoxy primers are best for bare metal and primer surfacers are best for plastics fiberglass or wood Some plastics may require an adhesion promoter but most plastics like ABS plastic are fine without adhesion promoters Our tech support department can assist with what primer is best if you are uncertain 7 Before applying your primer remove all dirt grease oil salt and chemical contaminants by washing the surface with a commercial detergent or other suitable cleaning method
3. r items as well Try using a brush to create Brush Strokes or even a sponge to create a Swiss Cheese or Snakeskin type of look This is only limited by your creativity Anything that will produce a texture in the wet Crazer can be used Experimentation is encouraged 18 Always try to texture your Crazer paint immediately after applying If you allow the Crazer to start to dry it will be less viscous and will not texture as well 19 Once you have finished texturing your Crazer paint let it dry for approximately 1 2 hours after removing the plastic wrap or whichever technique you chose and then clear coat with any good quality clear such as Alsa s Mirraclear part number KC MCLR
Download Pdf Manuals
Related Search