Veranda 73014858 Instructions / Assembly
Contents
1. Boards Rail Clips Custom Notches 2 or 2 Rail Clips 73014079 Rail Notcher Tool If reducing the width of a gate be sure to take into consideration any inserts or channels inside the post uprights and cut the rail lengths as required Fig 2 Post Upright lt Post Upright i P Channel Gate Insert Finish assembling the rest of the fence or gate panel by following the respective installation instructions2. Barala g Reducing Fence Panels amp Gates Reducing the Height of Ready To Assemble Panels amp Gates 1 Cut boards and U channels to desired height Fig 1 E U Channel Boards Creating an Angled Panel a Keep in mind the top rail will be longer than the bottom rail due to the angle Make sure it is long enough to cover the width of the panel once the angled cut is made NOTE e Cut the ends of the rails at an angle parallel with the post Fig 2 e Scalloped panels are numbered on the bottom of the boards Write the board number in marker above the cut line to avoid losing track of the numerical order after cutting Fig 3 b The top post holes my need to be elongated to accept the top rail start with small increments to ensure a tight fit without an open gap c Mark the boards with a chalk line to guide the angled cut d Secure rails into route holes with one of the methods below Rail Clips Rail Clips 73014079 Rail Notcher Tool To cut posts measure the height of the new panel picket X Add 3
3. to the panel picket a height from the bottom of the bottom rail hole to the top of the post Mark a line and cut the post at the line or as project requires Fig 4 NOTE For panels with 3 rails reroute the bottom post hole to avoid having to reroute both top holes instead If cutting the bottom of a post do not add 3 to panel picket height 3 a Measure area for post route hole Make route centered on sides amp square to post Drill holes in corners of area to be routed Make sure you drill holes large enough for a jig saw blade Cut to line amp clean opening Use a jig saw to cut opening and clean with a file Insert rail into route hole of post and secure Fig 5 b Finish assembling the rest of the fence or gate panel by following the respective installation instructions Reducing the Width of Ready To Assemble Panels amp Gates 1 2 3 Simply remove boards from panel and cut rails to desired length make sure rails are 3 wider than the finished panel size so that the rails can be inserted into the post routes Fig 1 For added security add rail clips notches or screws to the end of the cut rails NOTE If cutting one of the vertical boards is necessary to achieve the desired panel width draw a line the length of the board and slowly cut using a fine tooth saw U Channel
Download Pdf Manuals
Related Search