Builders Edge 050010212000 Installation Guide
Contents
1. of shutter window 1 09 14 1 0027 MIPC8517 Step 3 With it s front facing the mounting surface align the shutter next to where it will be mounted On the lines Ane drawn in the previous step sketch marks corresponding to the mounting areas of the shutter correct placement areas for Shutter Clips next to window Figure 4 fasten with bracket up away from window optional Figure 3 sketch marks x x x x x x Step 4 Read all of Step 4 and view Figure 4 before installing Shutter Clips to mounting surface Fasten the shutter clips centered on the vertical line and between the sketch marks drawn in Step 3 Use one screw next to the window and two screws in the shutter clips away from the window See Figure 4 These clips should be free to move with temperature changes The mounting bracket on the Shutter Clip should be placed in the upright position Different mounting surfaces may require special mounting procedures or techniques Step 5 After the Shutter Clips are in position and fastened to the mounting surface attach the2. shutter Place the shutter over the Shutter Clips and press the ribs of the shutter on to each Shutter Clip Press the shutter firmly against the mounting surface being sure all six clips engage
3. Part No MIPC8451 Shutter Clip Installation Instructions N For Installation of Standard Louvers Panels Board and Battens and custom Board and Batten Shutters only Required for Installation e Six Shutter Clips per shutter correct placement areas for Shutter Clips e Nine 10 or equivalent M5 metric screws per shutter Length of screws is dependent on mounting surface e Other fasteners may be required for specific surfaces e Screw driver electric drill level and pencil Installation Notes Each shutter has ribs in the back of the top center and bottom panels Two clips are used in each of these three areas See the illustration at the right Figure 1 Step 1 Push a shutter clip partially onto the ribs at each corner of the shutter with the mounting tab extending beyond the shutter 4 places See Figure 1 DO NOT press the Shutter Clips completely on to the shutter at this time because they will be removed later Step 2 Hold the shutter against the mounting surface in the position f Do not completely where it will be attached Mark the center hole of each shutter 1 fasten Shutter Clips clip 4 places Draw lines vertically between the top and bottom to shutter at this time marks After completing Step 2 remove the Shutter Clips from the shutter pencil marks TI Com a j M Figure 2 j window trim top
Download Pdf Manuals
Related Search