White Rodgers 760-56 Flame Sensor Installation Instructions
Contents
1. WHITE RODGERS 760 Series Electrodes INSTALLATION INSTRUCTIONS Operator Save these instructions for future use FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE PERSONAL INJURY AND OR PROPERTY DAMAGE The 760 series electrodes are made in various configura tions to meet the specific requirements of different appli cations Depending on electrode design they may be used for spark ignition flame sensing or a combination of both THESE CONTROLS MUST BE INSTALLED BY A QUALIFIED INSTALLER All wiring must conform to local and national electrical codes and ordinances Do not use on circuits exceeding specified volt ages Higher voltages will damage control and could cause shock or fire hazard Shut off main gas to heating system until installa tion is complete GY WHITE RODGERS DIVISION pea EMERSON ELECTRIC CO val 9797 REAVIS ROAD MEME ST LOUIS MO 63123 5398 314 577 1300 FAX 314 577 1517 Printed in U S A DESCRIPTION These electrodes are not universal replacements They can only be used to replace the identical type in applica tions where it was originally installed by the equipment manufacturer If the electrode you are replacing is not the same type number contact the original equipment manu facturer OEM for a suggested replacement To prevent electrical shock and or equipment damage disconnect electric power to system at main f2. use or circuit breaker box until installation is complete Label all wires prior to disconnection when ser vicing controls Wiring errors can cause improper and dangerous operation Following installation or replacement follow appliance manufacturers recommended instal lation service instructions to insure proper operation PART NO 37 5636A 9645 INSTALLATION If the equipment manufacturer has provided installation instructions follow those instructions If none are avail able use the following general replacement instructions as a guideline On assemblies with three electrodes do not dis assemble ground plate from electrode assembly This could change the factory set gap causing poor ignition Shut off electric power and gas supply to the heater or device until installation is complete Remove existing electrode assembly Be sure to label all wires before disconnecting This will help when reconnecting leads to the new electrode as sembly Install new electrode assembly Make sure that new electrode is inthe same position relative to the burner as the old electrode Attach using screws or hardware previously removed Connect all wires Turn on gas and electrical power to the system Check the system for proper operation Follow the appliance manufacturer s recommended installation and or service instructions to insure proper operation
Download Pdf Manuals
Related Search