Triarch 31402-54 User's Manual
Contents
1. S wasner T nut U iron washer v pige B fixture arm D nut Q nut secure air fuser oO T Flusn part neck nrg x gass washer bag Le GO M cottom zap N finial Assembly instruction for 31402 54 1 connect fixture arm B with flush pan C 2 Install fixture 1cop A to fixture B for pendant only with poly ball R washer S unt T iron washer U 2 Jee the tock up aut Q to conmet with Sxture B and loop A 4 Aciust arms to space evenly 5 Install light bulbs not provided 6 Secure glass J with center pipe E nipple F check ring G g ass wesher p nut D glass washer K aut L settom cap M and nial CN a 7 Connect electrical wires at junction box and secure crossbar nipple and canopy loop Assembly Instruction for the fixture with safety cable NOTE Fixtures weighing over 50 lbs must be supported independently of the outlet bos 1 Turn off power 2 Supply wires shall cuter the outlet box through any knockout except the top center knockout 3 Fixture is to be mounted by a steel pipe approxtmutely 3 4 of 3 8 18NPSN threads at buttom Not Supplied Position pipe so that approximately 1 2 of thread protrudes into outlet box Attach pipe to a Structural Bridging structural bridging member of sufficient strength to support at least 4 times Member the fixture weigh 4 Thread pipe coupling onto protruding2. inside outlet box 5 Thread hex nut onto threaded pipe Screw threaded pipe into pipe coupling Secure in place by tightening hex out against pipe coupling and Clamps tightening allen head scerw 6 Thread bexnut Ship on ground wire and thread a second hex nut onto threaded pipe 7 Connect screw collar loop without threaded ring to threaded pipe 8 Pass canopy over screw collar loop Approximately one half of the screw collar loop exterior thread should be exposed Adjust loop as required Remove canopy and tighten hex nut against screw collar loop Tighten second hex nut against first to hold ground wire in place 9 Attach chain to fixture not shown 10 Slip threaded ring then canopy onto chain 11 Attach chain with fixture connected to bottom of screw collar loop 12 Weave silver support cable up chain and exit through top holc in side of pipe coupling Slip cable through top existing opening or drill 3 16 dia Hole near center of outlet box Wrap cable around structural member described in step 3 Cable must be pulled tanul to evenly distribute fixture weight between cable and chain Secure cable with 2 clamps Allen Head Screw provided 13 Weave both fixture wires and copper ground wire up chain and cxit through top hole inside of pipe coupling am 14 Connect fixture ground wire and ground wire attached to threaded pipe Ground Wire to outlet box ground wire with wire connector not provided Never connect ground wire to black or
3. power supply wires eee Make wire connectings connectors not provided Reference chart below Threaded Pipe P for correct conacctions and wire accordingly Support Cable Outlet Box Pipe Coupling Hexnut Connect Black or Connect Black or Red Supply Wire to White Supply Wire to White Screw Collar Loop Black Parallel cord square amp ridged Parallel cord round amp smooth Clear Brown Gold or Clear Brown Gold or Black without tracer Black without tracer Insulated wire other than green with copper conductor Insulated wire other than green with sliver conductor Notes When parallel SPTI amp SPTIL are used The Neutral wire is square shaped or ridged and the other wire A Will be round in shape or smooth sce us Chain Warning Consult a qualifie Electrician for installation EN Light loop
Download Pdf Manuals
Related Search