TRENDnet TEW-AI86D User's Manual
Contents
1. It is only necessary if you decide to mount the TEW AI86DB at a permanent location Use discretion when attaching mounting brackets to the TEW AI86DB If you have any questions regarding the TEW AI86D TEW AI86DB please contact TRENDnet Technical Support Department Certifications This equipment has been tested and found to comply with FCC and CE Rules Operation is subjectto the following two conditions 1 This device may not cause harmful interference 2 This device must accept any interference received Including interference that may cause undesired operation Waste electrical and electronic products mustnot FC C gp disposed of with household waste Please recycle where facilities exist Check with you LocalAuthority orRetailerforrecyclingadvice NOTE THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT SUCH MODIFICATIONS COULD VOID THE USER S AUTHORITY TO OPERATE THE EQUIPMENT Limited Warranty TRENDnet warrants its products against defects in material and workmanship under normal use and service for the following lengths of time from the date of purchase TEW AI86D TEW AI86DB 3 Years Warranty If a product does not operate as warranted above during the applicable warranty period TRENDnet shall at its option and expense repair the defective product or part deliver to customer an equivalent product or par2. TRENDnet User s Guide NNI mm TEW AIS86D TEW AIS6DB B Table of Contents EOE narn 1 Bene Ton DE u 1 2 Hardware Installation ees 2 TOUTE SAO OLIN MU 7 Version 01 04 2006 1 Before you start Package Content m e TEW AI86D TEW AI86DB s Antenna Mounting Base TEW AI86DB only User s Guide Mounting Kit TEW AI86DB only Product details The Directional Indoor Antenna has a reverse SMA female connector that can be connected to your Access Point or Wireless Network Adapter Z WARNING The antenna can tilt 0 to 180 and rotate 3607 The Internal antenna wire is fixed therefore do not rotate the antenna beyond 360 Wall partition mount Antenna base with embedded magnets For antenna deployment you can mount the antenna onto a wall using the fasteners and screws included or simply stick to metal surfaces B 2 Hardware installation Recommended devices to connect with this antenna Wireless base stations with detachable antenna s As a method of focusing signal broadcast to achieve longer range coverage in your home or office the antenna generates an 80 wide directional signal AN Recommendation Due to the bi directional nature of WiFi devices receive transmit itis recommended that you install external antennas on the AP base station as well as the client Recommended installation positions T
3. IN LIEU OF ALL OTHER WARRANTIES EXPRESSED OR IMPLIED EITHER IN FACT OR BY OPERATION OF LAW STATUTORY OR OTHERWISE INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE TRENDnet NEITHER ASSUMES NOR AUTHORIZES ANY OTHER PERSON TO ASSUME FOR IT ANY OTHER LIABILITY INCONNECTION WITH THE SALE INSTALLATION MAINTENANCE OR USE OF TRENDnet S PRODUCTS TRENDnet SHALL NOT BE LIABLE UNDER THIS WARRANTY IF ITS TESTING AND EXAMINATION DISCLOSE THAT THE ALLEGED DEFECT IN THE PRODUCT DOES NOT EXIST OR WAS CAUSED BY CUSTOMER S OR ANY THIRD PERSON S MISUSE NEGLECT IMPROPER INSTALLATION OR TESTING UNAUTHORIZED ATTEMPTS TO REPAIR OR MODIFY OR ANY OTHER CAUSE BEYOND THE RANGE OF THE INTENDED USE OR BY ACCIDENT FIRE LIGHTNING OR OTHER HAZARD LIMITATION OF LIABILITY TO THE FULL EXTENT ALLOWED BY LAW TRENDnet ALSO EXCLUDES FOR ITSELF AND ITS SUPPLIERS ANY LIABILITY WHETHER BASED IN CONTRACT OR TORT INCLUDING NEGLIGENCE FOR INCIDENTAL CONSEQUENTIAL INDIRECT SPECIAL OR PUNITIVE DAMAGES OF ANY KIND OR FOR LOSS OF REVENUE OR PROFITS LOSS OF BUSINESS LOSS OF INFORMATION OR DATE OR OTHER FINANCIAL LOSS ARISING OUT OF OR IN CONNECTION WITH THE SALE INSTALLATION MAINTENANCE USE PERFORMANCE FAILURE OR INTERRUPTION OF THE POSSIBILITY OF SUCH DAMAGES AND LIMITS ITS LIABILITY TO REPAIR REPLACEMENT OR REFUND OF THE PURCHASE PRICE PAID AT TRENDnet S OPTION THIS DISCLAIMER OF LIABILITY FOR DAMAGES WILL NOT BE AFFECTE
4. D IF ANY REMEDY PROVIDED HEREIN SHALL FAIL OF ITS ESSENTIAL PURPOSE Governing Law This Limited Warranty shall be governed by the laws of the state of California AC DC Power Adapter Cooling Fan and Power Supply carry 1 Year Warranty 9 TRENDnet TRENDnet Technical Support US Canada Support Center European Support Center Contact Contact Telephone 1 866 645 3673 Telephone Email support trendnet com E ospiti 5921 8288480 SUpp Francais 49 0 6331 268 461 0800 90 71 61 num ro vert Espanol 49 0 6331 268 462 English 49 0 6331 268 463 Tech Support Hours Italiano 49 0 6331 268 464 Dutch 49 0 6331 268 465 24 7 Toll Free Tech Support Fax 49 0 6331 268 466 Tech Support Hours 8 00am 6 00pm Middle European Time Monday Friday Product Warranty Registration Please take a moment to register your product online Go to TRENDnet s website at http www trendnet com TRENDNET 3135 Kashiwa Street Torrance CA 90505 USA Copyright 2006 All Rights Reserved TRENDnet
5. EW AI86D antenna has directional 80 signal coverage Therefore the ideal position for the antenna is in the corner of the covered area TEW AI86D antennas can also be placed atthe side edge of the covered area for long range hall corridor transmission Antenna Base Mounting Methods amp Confiquration AN PLEASE READ THE FOLLOWING INSTALLATION STEPS BEFORE DRILLING HOLES IN THE WALL Press Tab Lift Cover Remove weight plate After removing the bottom cover from its seating remove the metal weight plate from the ceiling clips to expose the screw holes In order to decrease the weight and increase the magnetic power it is highly recommended that the metal plate be removed before installing antenna onto ceiling partition or any metal surface Select location Place Mark screw base template position WARNING Please make sure that the AP Client device can reach your selected antenna position Antenna Cable is 1 meter 3 feet After you have marked the wall for the appropriate drilling sites re assemble the antenna stand without the metal weight The clips should not protrude About the screws After drilling holes in the drywall gypsum plasterboard sink the plastic anchor into the hole 1 8 inch drill bit 3mm Leave about 3 to 5mm 1 8 inch of the threaded screw exposed as depicted in the diagrams below a n Ceiling Mount Using Ceiling Clips or Magnets The specia
6. l ceiling mount feature is mainly recommended for use when your wireless base station is hidden over the ceiling or some kind of anti theft protection case is implemented How to assemble the antenna stand for use with ceiling systems Press tab and lift Turn over cover remove metal weight plates exposing the ceiling clips Secure Clips to Tee Conceal AP Router Note If the ceiling tees are made of steel turning the antenna base cover over may not be necessary because the base has embedded magnets which can be used to adhere the antenna to the ceiling tee B Troubleshooting Q1 How come cannot transmit or receive Wi Fi signals with my TEW AI86D A1 The TEW AI86D is a directional antenna and can only send and receive signals from the front panel Make sure to adjust the position of the antenna by directing the front panel to laptops PCs or other wireless devices Q2 My access point indicates that it is receiving power and my laptop is within range of the TEW AI86D However my laptop does not receive any signals from my access point A2 Make sure that you properly connect the antenna to the Wi Fi Access Point See 2 Hardware Installation Q3 Why won t the TEW AI86D work with my IEEE 802 11a Wireless Router or Access point A3 Yes The TEW AI86D is compatible with IEEE 802 11a b g wireless devices Q4 Is it necessary to use the tapping screws or the wall anchors that come with the TEW AI86DB
7. t to replace the defective item or refund to customer the purchase price paid for the defective product All products that are replaced will become the property of TRENDnet Replacement products may be new or reconditioned TRENDnet shall not be responsible for any software firmware information or memory data of customer contained in stored on or integrated with any products returned to TRENDnet pursuant to any warranty There are no user serviceable parts inside the product Do not remove or attempt to service the product by any unauthorized service center This warranty is voided if i the product has been modified or repaired by any unauthorized service center ii the product was subject to accident abuse or improper use iii the product was subject to conditions more severe than those specified in the manual Warranty service may be obtained by contacting TRENDnet office within the applicable warranty period for a Return Material Authorization RMA number accompanied by a copy of the dated proof of the purchase Products returned to TRENDnet must be pre authorized by TRENDnet with RMA number marked on the outside of the package and sent prepaid insured and packaged appropriately for safe shipment WARRANTIES EXCLUSIVE IF THE TRENDnet PRODUCT DOES NOT OPERATE AS WARRANTED ABOVE THE CUSTOMER S SOLE REMEDY SHALL BE AT TRENDnet S OPTION REPAIR OR REPLACEMENT THE FOREGOING WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE
Download Pdf Manuals
Related Search