Toyota 250-3642 User's Manual
Contents
1. 1994 TOYOTA TRUCK WITH 4 CYL ENGINE THROTTLE LEVER ADAPTOR PACKAGE 250 3642 1 Remove the throttle shaft nut and lock washer from the throttle shaft Install the Throttle Lever Bracket Reinstall the lock washer and hex nut NOTE Start the nut by hand to prevent cross threading Do not over tighten 2 Install the Snap in adapter from the cruise control kit onto the cruise control cable NOTE Aminimum of 1 8 of the cruise control cable must be exposed past the end of the snap in adaptor See Figure 1 Nut amp Lockwasher Ass y 1 4 20 P Adaptor Throttle Threaded Snap In Module Cable MUST Extend Past Adaptor Figure 1 3 Install the cruise control cable bracket on vehicle accelerator cable bracket by loosening only the REAR accelerator cable nut and inserting the cable bracket between the nut and vehicle accelerator cable bracket Retighten the accelera tor cable nut 4 Install cruise control cable into cable bracket by pushing the snap in adaptor into the square hole of the cable bracket Form 2645 6 94 5 Connect cruise control cable to the throttle lever using bead chain and the eyelet connector from the cruise kit Secure the eyelet connector to the throttle lever using the two plain washers and self locking pin provided in the throttle adaptor kit See Figure 2 Loasen This Bracket Cable Nut gi Bead Chain NLY r Connector Cover 1 8 of cable MUST A be exposed QS Saap In Adaptor Bead Chai2. n Connector Bead Chain N Bracker Throttle N Bead Chain E SO ae ead Chain Eyelet 5 Connector Pin Self Lacking Figure 2 6 Insure that the cruise control cable is not holding the throttle open in any way and allows freedom of movement without possibility of binding or hanging up R ROSTRA N PRECISION CONTROLS INC ROSTRA PRECISION CONTROLS INC 1994 ALL RIGHTS RESERVED PRINTED IN THE USA
Download Pdf Manuals
Related Search