Sony VPCB1190X Replacement Instructions
Contents
1. SONY VPCB1 Series Optical Disk Drive j e Replacement Instructions IMPORTANT PLEASE READ BEFORE YOU START These easy instructions are intended to guide you through the replacement process v Before you begin place your notebook computer on a clean or covered surface to avoid damage to the computer s case v Follow the ESD Electrostatic Discharge damage prevention instructions o Hold parts by the edges away from exposed circuitry when possible o Donot walk around excessively as this promotes static build up v Before you begin remove any jewelry you may be wearing to prevent scratches to the surface of your notebook computer v The appearance of the electronic components shown in the illustrations may be different from the components shipped This slight difference does not affect the accuracy of these instructions Sony is not responsible for damage caused by incorrect handling of the notebook computer Lift to remove Prepare the Computer Battery Pack Removal Optical Drive Removal Steps 3 6 Do Make sure _the computer is turned off the lid is Step 2 _ closed and the AC Adapter 1 Slide the left battery tab to the Step 3 The Optical Disk Drive ODD i unlock position i disconnected Failure to do so aa 2 With your right thumb slide the is located on the left side of the unit result in damage to the computer right battery tab to the left and hold 45 shown l 3 Lift the battery with your2. ion the new ODD Label Step 13 Using the ODD Screws install sit flush with silver side of ODD side down with brackets and screws as the ODD Brackets onto the new ODD shown zF pl n BEDEN ODD Installation Steps 14 16 Step 14 Align the ODD assembly Step 15 Make sure the new ODD is Bay screw to secure the ODD Drive properly label side down and slide into seated flush on the edge of the the computer computer Step 16 Reinstall the one 1 ODD Step 17 Reinstall the battery pack and AC Adaptor Return the old ODD to Sony following the included shipping instructions P N 989201344 Rev B 3 3
3. left thumb Step 1 Place the computer upside using the notch at the bottom to down on a protected surface with the remove front edge facing you P N 989201344 Rev B 1 3 Step 4 Using the enclosed magnetic screwdriver remove the one 1 screw securing the ODD Bay Put aside the ODD Bay screws to re secure the ODD Bay later in the procedure VPCB1 Series Optical Disk Drive Replacement Instructions Step 5 Insert your fingers in the space between the ODD and the unit Gently pull towards the left to remove the ODD Step 6 Carefully remove the ODD assembly from the unit ODD Disassembly Steps 7 9 Step 7 Identify the two 2 side screws that secure the ODD brackets to the ODD Step 8 Remove the screws amp bracket Put the ODD Brackets and screws aside for transfer to the new ODD Step 9 Arrange the brackets amp screws as shown above Set the old ODD aside ODD Assembly Steps 10 13 Step 10 Take the new ODD and bezel provided in the CRU kit and prepare for assembly Bezel Tab i oe ODD Tab Hole NOTE dentify tabs on the bezel and tab holes located on the ODD 2 3 Step 11 Align the tabs on the bezel with the tab holes located on the ODD Carefully press the bezel into place SONY VPCB1 Series Optical Disk Drive Replacement Instructions Note Flat surface of bracket should Step 13 Posit
Download Pdf Manuals
Related Search