Sony CRX320EE User's Manual
Contents
1. Package Contents Please verify that the package includes the following accessories with the drive when unpacking If any of these items appears to be missing or damaged please contact your supplier e CD RW DVD ROM drive e Product Information this document e Warranty card Specifications Compatible discs CD R CD RW CD ROM CD ROM XA CD DA CD Extra CD Video CD CD TEXT Photo CD DVD ROM DVD Video Disc diameter 12 cm 8 cm for horizontal use only D This product is designed to playback discs that conform to the Compact Disc CD standard Recently various music discs encoded with copyright protection technologies are marketed by some record companies Please be aware that among those discs there are some that do not conform to the CD standard and may not be playable by this product When you use this unit as an audio CD player please use compact discs with the following mark OSE DIGITAL AUDIO Writing Systems Track at once Session at once Disc at once Packet writing Drive Data transfer rate CD ROM Up to 7800 KB s 52x speed DVD ROM Up to 22160 KB s 16x speed Access time Average random stroke CD ROM 120 ms DVD ROM 140 ms When using the Turbo Boost function The maximum data transfer rate depends on the capabilities of the host PC Please note that specifications and appearance may be subject to change without notice Buffer under run error protec2. Safety Regulations WARNING You are cautioned that any changes or modifications not expressly approved in this document could void your authority to operate this equipment To prevent fire or shock hazard do not expose the unit to rain or moisture To avoid electrical shock do not open the cabinet Refer servicing to qualified personnel only CAUTION As the laser beam in the CRX320AE is harmful to the eyes do not attempt to disassemble the cabinet Refer servicing to qualified personnel only The use of optical instruments with this product will increase eye hazard The use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure This label is located on the top of the drive unit enclosure Dieses Etikett befindet sich an der Oberseite des Laufwerksgehauses CAUTION CLASS 3B VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN AVOID DIRECT EXPOSURE TO THE BEAM ATTENTION RADIATIONS LASER VISIBLES ET INVISIBLES DE CLASSE 3B EN CAS D OUVERTURE EVITER TOUTE EXPOSITION DIRECTE AU FAISCEAU VORSICHT KLASSE 3B SICHTBARE UND UNSICHTBARE LASERSTRAHLUNG WENN GEOFFNET DIREKTEN KONTAKT MIT DEM STRAHL VERMEIDEN ADVARSEL SYNLIG 0G USYNLIG LASERSTR LING AF KLASSE 3B VED BNING UNDG DIREKTE UDS TTELSE FOR STR LING ADVARSEL SYNLIG 0G USYNLIG LASERSTR LING KLASSE 3B N R DEKSEL PNES UNNG DIREKTE EKSPONERING FOR STR LEN VARNING KLASS 3B SYNLIG O
3. may be lower e If no spare power connector is available a Y adapter is necessary e It is not necessary to connect the audio cable if your PC supports digital playback Using the wrong type of cable with this product can cause it to malfunction Follow the instructions when connecting the product Product and Support Information Sony Site Information As of November 2004 Product purchased in Europe http www sonydigital link com OSD Local Web sites for computer peripheral products Technical Support Please consult the above sources before calling with questions about using this product or with technical questions about the drive or the supplied software If using telephone or e mail support please have the following information available e Model number CRX320AE e Serial number e Date and place of purchase e Computer maker and model number e Computer specifications CPU speed memory size OS version etc e Writing software used version etc Local technical support is only available in the specified sales regions The customers in these regions should be provided with a warranty card for this product For contact information refer to the warranty card Note that technical support conditions may vary according to the locality and that charges and or limited service may apply in some regions
4. that the pin 1 side is connected to pin 1 on the motherboard e The power connector must be inserted with the inclined side upwards software Check your software license agreement for details Turbo Boost Function The default CD R and CD ROM read write speed of this drive is 40x speed With a single touch you can activate the Turbo Boost function making the read write speed 52x speed e On rare occasions some discs may not be able to tolerate 52x speed causing them to break We recommend that you do not use deeply scratched brittle or other discs that may break at 52x speed The Turbo Boost function does not increase read write speed with CD RW or DVD ROM discs 1 Insert a disc into the drive The speed when you insert a disc is normally 40x speed 2 Press the Eject button for five seconds The Busy indicator blinks twice and the speed switches to 52x speed The Turbo Boost function is active When you want to write at 52x speed insert the disc into the drive activate the Turbo Boost function and then start writing to the disc e When writing with the Turbo Boost function the Busy indicator blinks more rapidly than usual About twice as fast as when writing at the default write speed e When you open the disc tray the speed reverts to its default of 40x speed The Turbo Boost function does not guarantee a 52x write speed Depending on the condition of the disc you are using the speed
5. CH OSYNLIG LASERSTRALNING N R DENNA DEL AR PPNAD UNDVIK ATT DIREKT EXPONERA DIG F R STR LNINGEN VARO AVATTUNA LUOKAN 3B N KYV JA N KYM T NT LASERS TEILY V LT SUORAA ALTISTUMISTA S TEELLE The CD RW DVD ROM drive is classified as a CLASS 1 LASER PRODUCT The CLASS 1 LASER PRODUCT label is located at the top of the enclosure Bei diesem CD RW DVD ROM Laufwerk handelt es sich um ein Laser Produkt der Klasse 1 Das Etikett mit der Aufschrift LASER KLASSE 1 LASER PRODUCT PRODUKT befindet sich auf der Oberseite des LASER KLASSE 1 Geh uses PRODUKT CLASS 1 LUOKAN 1 LASERLAITE KLASS 1 LASER APPARAT FCC Compliance This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures e Reorient or relocate
6. ing speed may automatically be adjusted depending on the disc specified speed or disc conditions such as weight imbalance and eccentricity e 1x and 2x writing speed and discs are not supported e During startup the drive may make a whirring noise due to balls contained in the ABS Auto Balance System spindle motor This is normal and does not indicate a drive malfunction System Requirements This CD RW DVD ROM drive can be used in systems with the following capabilities Q CPU Pentium II 400 MHz or higher is recommended Q PC AT compatible PC Q OS Windows 98 Second Edition Windows 2000 Professional Windows Millennium Edition Windows XP Home Edition Windows XP Professional 64 MB RAM or higher is recommended At least 1 GB available hard disk space One available EIDE ATAPI interface connection with DMA capability Ooo Q One empty 5 inch half height drive bay Q One available internal 12 V 5 V power connector e The above system configuration is given as a minimum requirement for a system on which basic CD RW writing performance can be obtained In actual use the requirements for the writing software and Windows also have to be taken into consideration Normally these requirements will be higher than the above specifications e The drive cannot be assured to operate properly if connected to an ATAPI interface adapter card we cannot guarantee compatibility or offer user support
7. nancial damage or loss of profit that might occur when using the supplied software The supplied software can only be used with this product Specifications of the supplied software may be changed without notice in the interest in product improvement Oo O O O 2 590 610 11 2 SONY CD RW DVD ROM Drive Product Information Included Documents Q Warranty card Q Product Information this document CRX320AE 2005 Sony Corporation Printed in China P N 7819901067A Precautions for Use Operation and storage conditions Avoid using or storing the drive in a hot or humid location or where it might be subject to severe vibration or direct sunlight On transportation If the drive is to be shipped while installed in a PC remove any disc beforehand Avoiding condensation problems As much as possible avoid sudden temperature changes Do not attempt to use the drive immediately after moving it from a cold to a warm location or raising the room temperature suddenly as condensation may form within the drive If the temperature changes suddenly while using the drive stop using it but keep the power on for at least an hour Handling discs e Handle discs only by the edges Never touch the recording surface Do not affix labels on discs e Do not store discs in dusty dirty or humid locations in direct sunlight or near heat generating devices To protect important data always keep discs in
8. s of Sony Corporation e Pentium is a registrated trademark of Intel Corporation e Microsoft MS MS DOS and Windows are registered trademarks of Microsoft Corporation e Other system and product names used herein are registered trademarks or trademarks of their respective manufacturers although the and marks are not used in the text Before using this device be sure to read the end user license agreements for the software provided with your computer Q Our product warranty is valid only when the supplied accessories including software are used in the specified or recommended system environment in accordance with the documentation and applies only to the CD RW DVD ROM drive Our customer service and user support apply only under these product warranty conditions Q Please note that we cannot accept responsibility for failure of the computer or other devices incompatibility with special hardware operating problems caused by improper installation of software loss of data discs or other accidental or incidental damage that might occur when using this product The guarantee and user support for this product are valid only within the countries or sales regions specified on the warranty card Copyright laws prohibit the copying in part or in full of the supplied software and documentation or loaning the software without obtaining permission of the copyright holder We cannot accept responsibility for any direct or indirect fi
9. the receiving antenna e Increase the separation between the equipment and receiver e Connect the equipment into an outlet on a circuit different from that to which the receiver is connected e Consult the dealer or an experienced radio TV technician for help Note If you have any questions about this product you may call the telephone number listed in the Product and Support Information section The telephone number below is not for customer service but for official purposes only Declaration of Conformity Trade Name SONY Model No CRX320AE Responsible Party Sony Electronics Inc Address 16450 W Bernardo Dr San Diego CA 92127 U S A Telephone No 858 942 2230 This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 This device must accept any interference received including interference that may cause undesired operation ol Ale 78822 AAD APSSS FHAA SE FE AAAH ASA RSC 71719 HA 144 CRX320AE PISBHSTO AS SONY KOREA HAAS HORA HEHHE SONY CORPORATION CHINA CE Sicherheitsbestimmungen Diese Ausr stung erf llt die Europ ischen EMC Bestimmungen fiir die Verwendung in folgender folgenden Umgebung en e Wohngegenden e Gewerbegebiete e Leichtindustriegebiete Diese Ausr stung erf llt die Bestimmungen der Norm EN55022 Klasse B e Power Burn and Power Bur i are trademark
10. their protective cases Do not wipe writable discs to clean them before recording data Instead use a blower to remove any dust e Data may not record properly if a scratch or dust is present on the unrecorded area of writable discs Use special care when handling Emergency Eject If the tray does not open with the Eject button turn the PC off and insert a thin tool such as a straightened paper clip into this hole to eject the tray manually OSs g About 40 mm 1 5 in CAUTION Depending on the product you are using the Emergency Eject Hole may be in a different location than illustrated above Introduction This product offers the following features Q An internal CD RW DVD ROM drive with ATAPI EIDE interface for PCs Writes up to 52x speed on CD R disc media Writes up to 32x speed on CD RW disc media Reads CD ROM discs at up to 52x speed With the Turbo Boost function easily switch from the default 40x read write speed to 52x speed Q Reads DVD ROM discs at up to 16x speed O O O UO For details see Turbo Boost Function below Q Features Power Burn conformed technology to prevent buffer under run errors Power Burn conformed is used to refer to a CD R RW that uses CD R RW recording technology ICs and or firmware other than Power Burn but provides performance equivalent to that of Sony original Power Burn technology based on the Power Burn concept e Writ
11. tion Power Burn conformed technology Operating Environment 5 to 40 C Power and Miscellaneous DC 5 V 15A DC 12 V 1L5A Size Approx 145 8 x 41 3 x 165 mm WxHxD excluding front bezel Weight Approx 0 9 kg drive only Interface Drive interface ATAPI EIDE compliant Drive Inquiry SONY CD RW CRX320EE Buffer capacity 2 MB Laser specifications Type CD RLD78PZW4 DVD RLD65MZT2 Wavelength CD 784 5 nm DVD 655 5 10 nm Output power CD 120 mW CW 230 mW Pulse DVD 10 mW Connecting the Cables e Connect one end of the audio cable to the ANALOG AUDIO connector on the drive and the other end to the audio input connector on your PC e Connect the IDE flat cable to the IDE connector on the drive e Connect an unused power connector from the PC power supply to the DC input power input connector on the drive Analog audio connector Audio cable E f a To computer To guard against possible loss or damage be sure to make a backup copy of the provided software disc on a CD R disc or other media The software disc is not sold separately Please Record Responsibly Before copying anything onto a CD R or CD RW disc make sure that you are not violating copyright laws Most software companies allow you to make a backup or archive copy of To sound card gt motherboard e The red side of the IDE flat cable indicates the pin 1 conductor Verify
Download Pdf Manuals
Related Search