Smeg DRY50V Instructions for Installation and Use
Contents
1. GB IE Contents INSTRUCTIONS FOR SAFE AND PROPER USE INSTALLATION OF THE STERILIZER DESCRIPTION OF CONTROLS USE OF THE STERILIZER CLEANING AND MAINTENANCE EXTRAORDINARY MAINTENANCE Da A DO N IDENTIFICATION HOT AIR STERILIZER MODEL DRY STERIL 60V YEAR OF CONSTRUCTION and carry out an inspection test 13 15 17 19 20 22 INSTRUCTIONS FOR THE INSTALLER these are intended for the qualified technician who must install the appliance set it functioning INSTRUCTIONS FOR THE USER these contain user advice description of the commands and the correct procedures for cleaning and maintenance of the appliance 12 Introduction GB IE 1 INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE STERILIZER WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE STERILIZER INSTALLATION MUST BE CARRIED OUT BY QUALIFIED ENGINEERS IN ACCORDANCE WITH THE REGULATIONS IN FORCE THIS STERILIZER IS INTENDED FOR COMMERCIAL USES AND CONFORMS TO CURRENT REGULATIONS IN FORCE THIS APPLIANCE MUST ONLY BE USED BY SPECIFICALLY AUTHORISED STAFF TRAINED IN ITS CORRECT USE THE APPLIANCE MUST ONLY BE USED FOR ITS INTENDED PURPOSE THE STERILIZATION OF SURGICAL INSTRUMENTS IN A MEDICAL AND PARA MEDICAL CONTEXT THE APPLIANCE MUST NOT BE USED FOR2. 2 2 Levelling Adjust the four feet so as to set the sterilizer on a perfectly level plane For this purpose loosen the lock nut and unscrew the foot The range of adjustment of the screw is 10 mm 16 Instructions for the user 3 DESCRIPTION OF CONTROLS THERMOSTAT KNOB This permits selection of the ideal cooking temperature Turn the knob clockwise to the desired temperature Adjustment is progressive so that the sterilizer also operates at any intermediate value When the knob is turned to the symbol the fan is switched on but the heating element is not TIMER KNOB This permits to select manual or timer controlled cooking with automatic turning off of the sterilizer at end of the cooking cycle For manual control of the cooking time turn the knob to the symbol L4 To set cooking time turn the knob clockwise Time is expressed in minutes 5 to 60 Adjustment is progressive so that time can also be set to any intermediate value Upon completion of the cooking cycle the knob automatically returns to 0 the sterilizer turns off and a buzzer signal is set off GB IE 17 ree S GB IE Instructions for the user ORANGE LIGHT When on indicates that sterilizer is heating up When the D set temperature is reached the light goes off During the cooking cycle the light comes on and goes off various times signalling that the temperature in the sterilizer is being kept constant as per the set val
3. REGISTRATION NUMBER AND BRAND NAME IS LOCATED IN AN EXPOSED POSITION AT THE REAR OF THE STERILIZER THE PLATE MUST NOT BE REMOVED THE APPLIANCE IS INTENDED FOR COMMERCIAL USE BY APPROPRIATELY TRAINED PERSONNEL CHILDREN SHOULD ALWAYS BE KEPT OUT OF ITS REACH AND NEVER BE ALLOWED TO PLAY WITH IT THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002 96 EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT WEEE THIS GUIDELINE IS THE FRAME OF A EUROPEAN WIDE VALIDITY OF RETURN AND RECYCLING ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT BEFORE THE APPLIANCE IS PUT INTO OPERATION ALL THE LABELS AND PROTECTIVE FILMS APPLIED INSIDE OR OUTSIDE MUST BE REMOVED The manufacturer declines all responsibility for damage to persons or things caused by non observance of the above prescriptions or by interference with any part of the appliance or by the use of non original spares THE WARRANTY COVERS PRODUCTION DEFECTS AND IS SUBJECT TO THE CONDITIONS OF THE CERTIFICATE WHICH ACCOMPANIES THE APPLIANCE GB IE Instructions for the installer SBE 2 INSTALLATION OF THE STERILIZER The sterilizer must be set up on a perfectly flat surface and left standing free Make sure to allow enough room at the back for easy access to the terminal strip for connection of the power cable to mains Installation must be carried out by a qualified technician in compliance with applicable regulations in force 2 1 Electrical connectio
4. lift the tabs at the corners as shown in the figure 22
5. TREATING CONTACT LENSES UNDER RULE 15 ANNEX 9 SUBSECTION 1 ALL OTHER USES ARE CONSIDERED IMPROPER THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER USE DO NOT LEAVE THE PACKING IN THE HOME ENVIRONMENT SEPARATE THE VARIOUS WASTE MATERIALS AND TAKE THEM TO THE NEAREST SPECIAL GARBAGE COLLECTION CENTRE THE STERILIZER IS SUPPLIED IN SUITABLE PACKAGING WHICH REQUIRES THE NORMAL PRECAUTIONS FOR TRANSPORTATION OF FRAGILE MATERIALS AS INDICATED ON THE PACKAGING ITSELF IF THE APPLIANCE IS RETURNED USE THE ORIGINAL PACKAGING IT IS OBLIGATORY FOR THE ELECTRICAL SYSTEM TO BE GROUNDED ACCORDING TO THE METHODS REQUIRED BY SAFETY RULES WHEN LINKING UP TO MAINS BY PLUG AND SOCKET MAKE SURE THAT BOTH ARE COMPATIBLE AND CONNECT BY MEANS OF A POWER CABLE COMPLYING WITH APPLICABLE REGULATIONS NEVER UNPLUG BY PULLING ON THE CABLE DO NOT OBSTRUCT VENTILATION OPENINGS AND HEAT DISPERSAL SLITS IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION TEST OF THE STERILIZER FOLLOWING THE INSTRUCTIONS BELOW SHOULD THE APPLIANCE NOT FUNCTION DISCONNECT IT FROM THE SUPPLY AND CALL THE NEAREST TECHNICAL ASSISTANCE CENTRE NEVER ATTEMPT TO REPAIR THE APPLIANCE 13 14 Introduction ALWAYS CHECK THAT THE CONTROL KNOBS ARE IN THE 0 OFF POSITION WHEN YOU FINISH USING THE STERILIZER NEVER PUT INFLAMMABLE OBJECTS IN THE STERILIZER THEY COULD BE ACCIDENTALLY LIGHTED AND CAUSE FIRES THE I D PLATE WITH TECHNICAL DATA
6. n Make sure that the power line voltage matches the specifications indicated on the rating plate located to the rear of the sterilizer This rating plate must never be removed The sterilizer is supplied complete with a HO7RN F three core supply cable for operation from a 230V power supply The standard cable is of the three core 230V 1 5 mm 3 x 1 5 mnf HO7RN F type If necessary the electrical supply cable should be replaced with an oil resistant type min HOSRN F 3 x 1 5 mr The yellow green earth cable on the end of the cable to be connected to the Sterilizer should be at least 20 mm longer 20 mm Make sure that plug and wall socket are of the same type and are in conformity with regulations in force Also check that the power supply line is provided with adequate earthing Avoid using adapters or shunters In case of permanent connection ensure that power cable is equipped with an easily accessible omnipolar switch fitted in proximity to the apparatus and with a gap between contacts equal to or greater than 3mm 15 CRIEN i GB E Instructions for the installer 2 1 1 Safety thermostat The sterilizer is fitted with a safety device which trips in case of serious malfunction To reset contact the nearest servicing centre or things caused by non observance of the above prescriptions or by The manufacturer declines all responsibility for damage to persons interference with any part of the sterilizer
7. s Remove the side guides by unscrewing the ring nut A and sliding them out of the rear hole B ze e Clean sterilizer grill and side guides with warm water and non abrasive detergents Rinse and dry e Clean the inside walls of the sterilizer with a soft cloth soaked in an ammonia solution rinse and dry In case of persistent spots or drip offs place an ammonia imbibed cloth on the bottom of the sterilizer close the door and after a few hours wash the sterilizer with warm water and a liquid detergent Rinse and dry 21 fe ae NGB IE Instructions for the user 6 EXIRAORDINARY MAINTENANCE The sterilizer may require extraordinary maintenance or replacement of parts subject to wear such as seals bulbs and so on The following instructions describe how to carry out these minor maintenance operations Before any intervention disconnect the power supply of the sterilizer 6 1 Removing the door Hinges with mobile connecting plates Catch the door at the two sides with both hands in proximity to hinges C and lift up the small levers D Lift the door upwards at an angle of about 45 and slide out To remount insert hinges C into the appropriate grooves allow the door to rest downwards and release the small levers D 6 2 Sterilizer door seal To permit thorough cleaning of the sterilizer the seal may be removed Before removing the seal take off the door as described above Once the door has been taken off
8. ting that the temperature in the sterilizer is being kept constant Upon completion of the cooking cycle the sterilizer automatically turns off the green light comes on and the buzzer sounds for a few seconds To completely turn off set the thermostat knob to 0 TIMER KNOB 30 ON ANY POSITION Ex THERMOSTAT KNOB 200 ON ANY POSITION Ex 19 G B E A 20 Instructions for the user 5 CLEANING AND MAINTENANCE Important never spray water directly on to the sterilizer Never use pressure nozzles Before any intervention disconnect the power supply of the sterilizer 5 1 Cleaning stainless steel parts To maintain stainless steel parts in perfect condition clean regularly at the end of the work day Allow to cool first To clean and preserve the stainless steel surfaces always use only specific products that do not contain abrasives or chlorine based acids How to use pour the product on a damp cloth and wipe the surface rinse thoroughly and dry with a soft cloth or deerskin Do not use metallic sponges or sharp scrapers they will damage the surface Use normal non abrasive products for steel and a wooden or plastic tool if necessary Rinse thoroughly and dry with a soft cloth or deerskin Instructions for the user GB IE 5 2 Cleaning the inside of the sterilizer To maintain the sterilizer in perfect condition clean it regularly at the end of the work day Allow to cool first Take off all removable part
9. ue GREEN LIGHT This light indicates that the thermostat knob is turned to any setting and does not go out until the thermostat knob is returned to zero or the safety thermostat is tripped When on it indicates that the safety thermostat with automatic reset has been tripped by an appliance malfunction cutting off the power supply The oven cannot be reused until this light goes out RED LIGHT THERMOMETER Shows the temperature reached inside the oven 18 Instructions for the user 4 USE OF THE STERILIZER 4 1 Warnings and general advice When using for the first time it is advisable to heat up the sterilizer to its maximum temperature for enough time to burn off any possible oily manufacturing residues 4 2 Pre heating Before sterilising preheat the appliance to the temperature required for at least 15 minutes 4 3 Manual cooking The sterilizer heats up as signalled by the orange light going on Upon the set temperature being reached the light goes off The orange light comes on and goes off various times during the cooking cycle indicating that the temperature in the sterilizer is being kept constant TIMER KNOB Ili SET TO MANUAL J THERMOSTAT KNOB 200 ON ANY POSITION Ex 4 4 Timed cooking The sterilizer heats up as signalled by the orange light going on Upon the set temperature being reached the light goes off The orange light comes on and goes off various times during the cooking cycle indica
Download Pdf Manuals
Related Search