SkyLink WS-100 User's Manual
Contents
1. maximum load specifications listed If you are not sure what is the rating of an appliance check with an electrician before plugging it into the receiver Operation Press the button on the transmitter battery already installed the light on the transmitter will turn on and the device you plugged into the receiver should also be on immediately Press the button on the transmitter again to turn the device off Battery Replacement Use 12 volt alkaline battery Type 23A To replace open the battery compartment cover and replace the old battery with a new one Do not dispose of battery in fire Battery may explode or leak Caution Risk of electric shock do not use with extension cord or near water or where water may accumulate Keep plugs and receptacles dry For use only on GFCI protected circuits Warranty If within one year from date of purchase this product should become defective except battery due to faulty workmanship or materials it will be repaired or replaced without charge Proof of purchase is required FCC This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation WARNING Changes or modifications to this unit not expressly approved by the party responsible of compliance could void the2. WS 100 Wireless Remote Control IMPORTANT SAFETY INSTRUCTION Introduction Skylink wireless remote allows you to operate any electrical appliance that meets the product s rating indoors or outdoors without rewiring Enclosed you will find Keychain transmitter with 12 volt alkaline battery installed Receiver Installation Plug in the receiver to an electrical outlet indoors Plug in the receiver to an electrical outlet fully The receiver requires a grounded outlet If you do not havea grounded outlet please contact an electrician to upgrade your electrical system If you are using the receiver outdoors read the extra pre cautions below Plug in the receiver to an electrical outlet outdoors Plug in the receiver to an electrical outlet fully Let the receiver hang downward so moisture doesn t accumulate in the outlet Install cord and unit above ground level with the receptacle in downward position A weather protective cover must be used in order to prevent rain or moisture from enter ing the unit Note Not for water immer Q sion or for use where direct exposed to water Store in doors when not in use Note The National Electrical Code and Canadian Electrical Code and most local codes require that outside outlets be protected by a Ground Fault Inter rupter GFI Power Outlet Plug in the device you wish to control into the outlet located on the bottom of the receiver Do not exceed the
3. user s authority to operate the equipment Skylink will not be held liable or responsible for any misuse or application of this product other than for its intended use RANGE Up to 100 feet INPUT 120VAC 60Hz MAXIMUM LOAD RESISTIVE eee 8A 960W INCANDESCENT 300W BATTERY TRANSMITTER 12 volt alkaline battery
Download Pdf Manuals
Related Search