Sears 139.53776 User's Manual
Contents
1. someone to help at this point The following procedure prevents the opener from learning the code of another remote control that is transmitting 1 Decide on a 4 digit code using numbers from 0 to 9 You can use a number more than once for example 4 0 4 1 2 Press the selected code digits on the keypad PRESS AND HOLD the ENTER button The keypad light will blink Press the Smart button on the opener end panel The adjacent indicator light will flash and the door will begin to move The receiver has now learned the selected keypad code After programming the keypad test your portable remote control If the pushbutton s no longer activates the door opener reprogram the remote control To change your code at any time repeat Steps 1 and 2 GARAGE DOOR OPENER RECEIVER With Smart Button A G gs e lt gt a4 Smart Indicator Button Light BATTERY The 12 Volt battery should produce power for at least one year As long as there is adequate power the keypad will illuminate and receiver will operate when number and ENTER keys are pressed Replace the battery when keypad illumination becomes dim 1994 Sears Roebuck amp Company 114A1399D All Rights Reserved Printed in Mexico2. SEAIRS OWNER S INSTRUCTIONS FEATURES OF THE MULTI FUNCTION KEYLESS ENTRY This remote control can be used with any 53000SRT series garage door opener receiver Personalized Code Up to 10 000 possible combinations Code can easily be changed if desired Operation Opener activates when 4 digit code and ENTER button are pressed If wrong numbers are accidentally pressed correction can be made immediately The ENTER key will transmit only the last four digits The keypad will blink for 15 seconds after the code is transmitted During that time you can STOP or REVERSE door travel just by pressing the ENTER key The Multi Function Keyless Entry can be used with any SMART receiver The keypad will illuminate for 5 seconds at the first push of ANY key All 53000SRT garage door opener receivers have a separate memory channel for the Multi Function Keyless Entry to operate the opener Power Supply 12 Volt battery MODEL 139 53776 MULTI FUNCTION KEYLESS ENTRY To comply with FCC rules adjustment or modification of receiver and or transmitter is prohibited except for changing the code setting and replacing the transmitterl battery THERE ARE NO OTHER USER SERVICEABLE PARTS Children operating or playing with a garage door opener can injure themselves or others The garage door could close and cause serious injury or death Install the door control or any additional push buttons out of the reach of children and away from a
3. ll moving parts of the door and door hardware but where the garage door is visible Do not allow children to operate the push button s or the remote control s A moving garage door could injure someone under it Activate the opener only when the door is properly adjusted you can see it clearly and there are no obstructions to door travel Open the keypad cover and remove the battery compartment screw Set cover aside and remove battery NOTE BATTERY POLARITY AS MARKED ON COMPARTMENT Follow the installation instructions described below INSTALLATION 1 Center the keypad at eye level against the selected location on the garage exterior as shown below NOTE For a one piece door on a brick stone or aluminum sided garage use the optional location shown in the illustration to avoid injury as the door swings up and out 2 Hold keypad firmly with cover half open so both top and bottom mounting holes are visible Use a punch to mark each hole Drill two 1 8 pilot holes Fasten securely with screws provided 3 Insert the plug provided into top hole to cover the fastening screw Return the battery being sure to observe polarity Refasten compartment cover Battery Cover Keypad KEYPAD MUST BE INSTALLED WITHIN SIGHT OF THE DOOR Exterior Front Wall 1 Piece or Sectional Door Door Jamb Edge Optional Location for 1 Piece Door Door Jamb Face Sectional Door Only SETTING THE CODE You may want
Download Pdf Manuals
Related Search