Sanyo TRC-6030 User's Manual
Contents
1. 8 9 10 k Cassette compartment lid COUNTER RESET Backspace control BACK SPACE Erase button and indicato ERASE i Stop button STOP Play button and indicator PLAY Speed control SPEED Fast forward button and indicator FFWD Rewind button and indicator REW 11 13 14 15 16 17 18 19 Volume control VOLUME 12 Search button and indicator SEARCH Tone control TONE Speed select button and indicators SPEED Power button POWER Speaker External DC 9V jack EXT DC 9V Remote control jack REMOTE Earphone jack EARPHONE E2 Dien Foot control 20 Back switch BACK 21 Play switch PLAY PREPARATIONS Connections aA 120VAC 60Hz Headset Foot control E3 Loading a microcassette 1 Pull the EJECT lever to open the cassette compartment lid 2 Load a microcassette with the full reel to the right 3 Close the lid by pressing it NOTES Besuretoclose the lid after loading a micro cassette The unit does not operate unless the lid is closed Do not atempt to operate the EJECT lever while the unit is operating When unloading a microcassette first press the STOP but ton and then pull the EJECT lever to open the lid Warning beep tones The unit emits a warning tone in the following cases No cassette A tone sounds if there is no cassette in the unit when the unit is inthe operating m2. N SANYO INSTRUCTION TRC 6030 MANUAL 7 MEMO SCRIBER Transcribing System SANYO S HELP LINE Call the toll free number below if you have any difficulties operating this product 1 800 421 5013 weekdays 8 00 AM 5 00 PM pacific time 1AD6P1P0165 E Issue Number 1 SANYO MEMO SCRIBER _ MODEL TRC 6030 LIMITED WARRANTY OBLIGATIONS In order to obtain warranty service the product must be delivered to and picked up from an Authorized Sanyo Service Center at the user s expense unless specifically stated otherwise in this warranty The names and addresses of Authorized Sanyo Service Centers may be obtained by writing to SFS Corporation SFC s warranty administrator at any of the addresses listed below or by calling toll free 1 800 421 5013 New Jersey Office California Office Illinois Office Georgia Office 210 Riser Road 1200 W Artesia Blvd 900 N Arlington Heights Road 1790 Corporate Drive Suite 340 Little Ferry NJ 07643 Compton CA 90220 Itasca IL 60143 Norcross GA 30093 201 641 3000 310 537 5830 708 775 1414 404 925 8900 THIS WARRANTY IS VALID ONLY ON SANYO PRODUCTS PURCHASED OR RENTED AND USED IN THE UNITED STATES OF AMERICA EXCLUDING HAWAII AND ALL U S TERRITORIES AND PROTECTORATES THIS WARRANTY APPLIES ONLY TO THE ORIGINAL RETAIL USER AND DOES NOT APPLY TO PRODUCTS USED FOR ANY INDUSTRIAL PROFESSIONAL OR COMMERCIAL PURPOSE THE ORIGINAL DATED BILL OF SA
3. LE SALES SLIP OR RENTAL AGREEMENT MUST BE SUBMITTED TO THE AUTHORIZED SANYO SERVICE CENTERAT THE TIME WARRANTY SERVICE IS REQUESTED Subject to the OBLIGATIONS above and EXCLUSIONS below SANYO FISHER USA CORPORATION SFC warrants this SANYO product against defects in materials and workmanship for the periods of LABOR and PARTS specified below SFC will repair or replace at its option the product and any of its parts which fail to conform to this warranty The warranty period commences on the date the product was first purchased or rented at retail LABOR PARTS 90 DAYS 1 YEAR EXCLUSIONS This warranty does not cover A the adjustment of customer operated controls as explained in the appropriate model s instruction manual or B the repair of any product whose serial number has been altered defaced or removed This warranty shall not apply to the cabinet or cosmetic parts knobs or routine maintenance This warranty does not apply to uncrating setup installation removal of the product for repair or reinstallation of the product after repair This warranty does not apply to repairs or replacements necessitated by any cause beyond the control of SFC including but not limited to any malfunction defect or failure caused by or resulting from unauthorized service or parts improper maintenance operation contrary to furnished instructions shipping or transit accidents modification or repair by the user abuse misuse neglect acci
4. dent incorrect line voltage fire flood or other Acts of God or normal wear and tear The foregoing is in lieu of all other expressed warranties and SFC does not assume or authorize any party to assume for it any other obligation or liability THE DURATION OF ANY WARRANTIES WHICH MAY BE IMPLIED BY LAW INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS IS LIMITED TO THE TERM OF THIS WARRANTY IN NO EVENT SHALL SFC BE LIABLE FOR SPECIAL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING FROM OWNERSHIP OR USE OF THIS PRODUCT OR FOR ANY DELAY IN THE PERFORMANCE OF ITS OBLIGATIONS UNDER THIS WARRANTY DUE TO CAUSES BEYOND ITS CONTROL SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS AND OR DO NOT ALLOW THE EXCLUSION OR LIMITATION OF CONSEQUENTIAL DAMAGES SO THE ABOVE LIMITATIONS AND EXCLUSIONS MAY NOT APPLY TO YOU THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS YOU MAY HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE S A R9 M ATTENTION For your protection in the event of theft or loss of this product please fill in the information below for your own personal records Model No Serial No Located on back or bottom side of unit a Date of Purchase S Purchase Price Where Purchased WARNING TO PREVENT FIRE OR SHOCK HAZARD DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE E1 CONTROLS 1 Eject lever EJECT 2 3 Tape counter and reset button 4 5 6 7
5. emical cleaners since these could damage the finish of your unit It is important that no Osame reaches the inside of the unit Cleaning the head For continued high performance periodically clean the head pinch roller and capstan wh never an accumulation of dust and red brown oxide particles is noticed To do this pull the EJECT lever to open the cassette compartment lid Remove the microcassette and switch off the power Carefully rub the head 4 pinch roller 3 and capstan 2 with a cotton swab 1 moistened with isopropyl alcohol or special head cleaning fluid SANYO 21350 Lassen Street Chatsworth CA 91311 Printed in Hong Kong
6. lease the PLAY switch Continue with this start stop method until the transcription is completed 10 To turn the unit off press the POWER button button UP E5 Index search 1 Press the SEARCH button button DOWN 2 Press the REW or FFWD button on the unit The tape stops briefly and a beep tone sounds when the tape reaches the index mark you have recorded When using the foot control press the BACK switch NOTE The index marks are made on the SANYO TRC 6300 Memo scriber Erasing After transcription is completed you can erase the microcassette 1 While holding down the ERASE button press the REW button The ERASE and REW indicators will light 2 When the tape reaches the end a beep tone sounds Press the STOP button to stop erasing You can also perform forward erasing by pressing both the ERASE and FFWD buttons Use as a tape player Youcanalso play apre recorded microcassette on the unit Loada microcassette and press the PLAY button Use the FFWD or REW button to advance or rewind the tape rapidly Safeguards against accidental erasure To protect side A break out tab 1 To protect side B break out tab 2 Torecord or erase a protected cassette cover the erase guard tab openings with adhesive tape 3 SR E6 A a EE BS TTS MAINTENANCE Cleaning the cabinet Use a clean soft cloth moistened with plain lukewarm water and wrung dry Never use benzol benzene or other strong ch
7. ode End of tape A tone sounds when the tape reaches the end in all operating modes Erase protection A tone sounds if you attempt to erase a microcassette whose erasure guard tab has been broken E4 TRANSCRIPTION 1 Press the POWER button button DOWN 2 Load the microcassette to be played _ 3 Press the RESET button to set the counter to 000 The tape counter helps you to quickly locate recorded selections for playback The tape counter will be set to 000 when the tape is ejected 4 Set the SPEED button to 2 4 or 1 2 to correspond with the recorded tape speed 5 Press the PLAY switch on the foot control to begin transcribing Play back will continue while the switch is being pressed Playback can also be started by pressing the PLAY button on the unit In this case the STOP button can be pressed to stop playback 6 Adjust the VOLUME and TONE controls as desired 7 Use the SPEED control to adjust the playback speed to your liking The 0 position on the scale is for normal tape speed 8 If you wish to review your dictation release the PLAY switch The tape automatically backspaces according to the BACKSPACE control setting Usethe BACKSPACE control to adjust the automatic backspace feature for your convenience For a longer review press and hold the BACK switch and the tape backspaces continuously until you release the BACK switch 9 To pause re
Download Pdf Manuals
Related Search