Playskool Flashlight User's Manual
Contents
1. 144 Ages 3 amp Up F ash ight ence mates located on this product CAUTION To avoid battery leakage s in Playskool Flashlight 1 Be sure to insert the batteries correctly and always follow the toy and battery manufacturer s instructions How to Install Batter Note to Parents Batteries should be installed by an adult The Playskool Flashlight operates on 2 C batteries not included For best performance alkaline batteries are recommended 2 Do not mix old and new batteries or alkaline standard carbon zinc or rechargeable batteries 3 Always remove exhausted or dead batteries from the BATTERY HOLDER HOLDER STEP 1 Locate tab on back end of flashlight Loosen STEP 2 Slide out battery holder Insert 2 C screw located above tab with a Phillips screwdriver batteries as shown in diagram located inside not included With thumbnail or coin move tab up to battery holder DONDN OMIM TERN STEP 3 Slide battery holder into flashlight until holder clicks securely in place STEP 4 Tighten screw to secure battery holder ON OFF Switch The manual ON OFF switch is located on top of flashlight handle A ON position Push switch towards front OFF position Push switch towards back Note Flashlight will emit light only when switch is in ON position and bar under handle is depressed ON OFF SWITCH AUTOMATIC OFF BAR Automatic Off Bar2. The Playskool Flashlight is designed to turn off automatically to conserve battery life To keep flashlight on when using hold flashlight by handle and lightly press bar located under handle When bar is released flashlight will shut off automatically after approximately 30 seconds How to Change Light Colors Your Playskool Flashlight has 3 colors of light white red and green TO CHANGE COLORS LOCATE ROUND FILTER KNOB ON SIDE OF FLASHLIGHT k men KN E For white light Turn knob lever so knob For red light Turn knob lever clockwise handle is horizontal to the right until it stops FILTER KNOB For green light Turn knob lever counter clockwise to the left until it stops How to Change Light Bulb NOTE A light bulb is included with your Playskool Flashlight If bulb should need replacing use a PR 2 light bulb 4 To replace light bulb remove battery holder from flashlight See Step 1 under How to Install Batteries Pull holder completely out of flashlight 2 Pull plastic cap from battery holder and discard light bulb Before discarding bulb be sure to remove and save the rubber bulb protector 3 Slip bulb protector onto new light and place new light in plastic cap Holding light bulb and cap together push light bulb into light bulb socket Make sure cap snaps securely in place le battery holder into flashlight until holder clicks Sag securely in place
3. Tighten h y 4 4 screw in back end of flash light to secure battery holder UGHT mu y user Pusnc BULS BULB pj PmOTECTOR SOCKET 1994 Playskool Inc Pawtucket RI 02862 U S A a subsidiary of Hasbro inc AJ Fights Reserved 6 denotes Reg U S Pat amp TM Office Made in Macau T4 amp PIN 45913100
Download Pdf Manuals
Related Search