Home
Philips MB4010T001 User's Manual
Contents
1. IBM PC connection 2 Mains connection T L Connection to the mains Rear of the monitor Y Mains cord 0 0 J il Connecting to the mains This monitor is set to operate at a mains supply of 100 240 volts AC If the mains voltage in your home is not between this consult your dealer Connect one end of the mains cord to the mains socket at the rear of monitor and the other end to the mains supply The monitor will be operating in power saving mode if you switch on your monitor without signal input from PC Please refer to Power Management Signalling instruction 8 Front Control locations and functions a For an optimized adjustment of the picture following controls are available at the front POWER Press this knob the green LED lights and the power is ON Press this knob again the green LED disappears and the power is OFF Q CONTRAST Used to adjust the picture contrast level BRIGHTNESS Used to adjust the overall screen brightness as a compensation for ambient light or Press or to adj
2. ESA 85 A User mode 15 modes 1024 x 768 800 x 600 48 3 60 Non interlaced Non interlaced The set will save the user s setting parameters automatically After 10 seconds of key pad inactivity the LED will flash twice to indicate the parameters being saved 11 B Power Management Signalling Power Management Definition VESA DPMS POWER SAVING STATES MODE VIDEO H SYNC V SYNC POWER USED POWER SAVING ON Active lt 70 Watts 0 Stand by Blanked lt 15 Watts gt 82 Suspend Blanked lt 15 Watts gt 82 OFF Blanked lt 8 Watts gt 94 Note The video will be blanked and the power LED color will change into following colors whenever the monitor goes into power management status Green LED light Normal operation Yellow LED light Stand by or Suspend mode Amber LED light OFF mode This monitor is Energy Star compliant when used with wh a computer equipped with DPMS As an Energy Star Partner MAGNAVOX has determined that this product meets the Energy Star guidelines for energy efficiency Remark The transition time from on mode to any power down mode will take around 5 seconds The recovery time from stand by or suspend mode to ON mode will take around 3 seconds 12 er Technical information I General Picture tube Screen area 14 inch 35 5 cm 90 deflection non glare black matrix l
3. MB4010T001 AutoScan Color Monitor English Operating Instructions 2 13 Francais Mode d emploi 14 25 Appendix English Declaration FCC A1 Information for Users in the U S A3 Warranty A5 Deutsch Hinweis GS A4 Achtung A6 Fran ais Declaration FCC A2 For Customer Use Enter below the Serial No which is located on the back of the cabinet Retain this information for future reference Model No MB4010T001 Serial No CAUTION RISK OF ELECTRICAL SHOCK DO NOT OPEN ATTENTION RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION TO REDUCE THE RISK OF ELECTRICAL SHOCK DO NOT REMOVE COVER OR BACK NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL This bolt of lightning indicates that uninsulated material within your unit may cause an electrical shock For the safety of everyone do not remove product covering A This exclamation point calls attention to a feature for which you should read the enclosed literature carefully to prevent operating and maintenance problems 2 Introduction The colour monitor displays sharp and brilliant images of text and graphics with a maximum resolution up to 1024x768 pixels It is optimal for Windows spread sheets and any other application This monitor automatically scans horizontal frequencies from 30KHz to 54KHz and vertical frequencies from 50Hz to 110Hz With microprocessor based digital con
4. al regulations on disposal of your old set SSS ey Installation Important Please refer to the user s manuals of your computer and video adapter to make sure these equipments are properly installed and configured before installing the monitor Positioning Ventilation Avoid exposing the monitor to direct sunlight stoves or any other heat sources To prevent overheating make sure that the ventilation openings of the monitor are not covered Keep moisture and dust away Keep away from any magnetic objects such as speakers electric motors transformers etc When positioning this monitor make sure that the mains plug and socket are easily accessible Pedestal With the built in pedestal you can tilt and or swivel the monitor for a most comfortable viewing angle To fit the pedestal refer to the illustration on the inside back cover of this manual PHILIPS CHENIN SHS ISS Tet 6 LEeE EiL EEE Connection Important Please make sure the AC power to your computer is OFF before connecting or disconnecting any display peripheral Failure to do so may cause serious personal injury as well as permanent damage to your computer equipments Intel Based platform 386 486 Pentium or other compatibles Connect the monitor to the computer using the supplied interface cables Monitor rear view 1
5. ideo ground X Because of a policy of continuous product improvement the above specifications are subject to change without notice
6. ight transmission 57 phosphor P22 medium short dotted pitch 0 28 mm Recommended Display Area 250 mm H x 188 mm V Maximum Display Area Line Horizontal frequency Raster Vertical frequency Mains voltage Power consumption Maximum dot rate Video input signal Sync type Sync Polarity Pedestal Unit dimension W x H x D Net weight Operating condition Temperature Humidity Storage condition Temperature Humidity DDC1 DDC2B II Compatibility 274 mm H x 201 mm V 30 54 KHz automatically 50 110 Hz automatically 100 240 VAC 60 50 Hz automatically 70 watt nominal 90 watt max 65 MHz 0 7 Vp p linear 75 Ohm Separate H V TTL level Positive or Negative Tilt 5 forward 13 backward swivel 90 leftward or rightward 356 x 370 x 382 mm 10 6 Kg 0 C to 40 C 20 to 80 25 C to 70 C 20 to 95 VESA standard Intel based platform 386 486 Pentium and other compatibles VESA Guide lines and Standards 13 III Pin assignment 1 The 15 pin D sub connector male of the signal cable IBM systems Red video input No pin Green video input Logic ground Blue video input Identification output Identification output connected to pin 10 Connected to pin 10 Serial data line SDA Ground H Sync EE Red video ground V Sync VCLK for DDC Green video ground Data clock line SCL Blue v
7. trolled circuit the monitor can automatically adjust itself to the video card s scanning frequency and displays an image with precise parameters you desire The wide range of scanning frequency supports variety of operating platforms such as IBM PC and compatibles including Intel based platforms such as 386 486 Pentium and Pentium Pro Feature Highlights e Global Styling demonstrates a soft amp smart image e Digital Control feature provides user friendliness and ease of use when operating the monitor e Anti Glare and Anti Static screen coating eliminate any bad effects caused by the screen surface such as reflection of the room lights and dust attraction 85Hz refresh rate The maximum display resolution is 1024 x 768 pixels non interlaced mode The recommanded optimum resolution up to 800 x 600 pixels non interlaced by maximum 85Hz refresh rate e Green Design including automatic power saving function NUTEK and low emission MPRII compliance shows our commitment in environmental care DDC1 DDC2B allows communication between the monitor and PC system for optimal video configuration Note If you experienced your monitor display is changing from color to mono it s possible that you are using a non VESA DDC standard video card Please consult with your local Philips dealer for more information As an Energy Star Partner MAGNAVOX has determined that this product meets the Energy Star guidelines for energy efficienc
8. ust the selected function The function pads 0 Q H Shift to adjust the horizontal position of the image H Size to adjust the horizontal amplitude of the image V Shift to adjust the vertical position of the image V Size to adjust the vertical amplitude of the image SHIFT key To select the level of function Shift LED off Control is on first level Shift LED on Control is on second level Second level of the function pads U mt Trapezoid to correct the trapezoid distortion of the image Pincushion to correct the barrel distortion of the image Recall to recall original factory preset mode Remarks 1 When pressing any function pad the Shift LED will flash once to indicate the function has been selected 2 Once the limit of the adjustable range has been reached the shift LED will flash continuously 10 Adjustment The monitor is pre set with 8 modes for optimal display size and centering as indicated in the following table Mode Resolution dots x lines Horizontal Freq KHz Vertical Freq Hz Remark VGA 640 x 350 31 5 70 Non interlaced VGA 640 x 400 31 5 70 Non interlaced VGA 640 x 480 31 5 60 Non interlaced VESA 75 640 x 480 37 5 75 Non interlaced VESA 60 800 x 600 37 8 60 Non interlaced VESA 75 800 x 600 46 9 75 Non interlaced VESA 60 V
9. y IBM IBM PC and Power PC are registered trademarks of International Business Machines Corporation 4 Safety precautions and maintenance Disconnect the monitor from the mains supply if the monitor is not to be used for an extended period of time Do not attempt to remove the back cover as you will be exposed to a shock hazard The back cover should only be removed by qualified service personnel Do not place objects on top of the monitor cabinet which could fall into vents or which could cover them and prevent proper cooling of the monitor s electronic devices Do not expose the monitor to rain or excessive moisture to avoid the risk of shock or permanent damage to the set Do not use alcohol or ammonia based liquid to clean the monitor If necessary clean with a slightly damp cloth Disconnect the monitor from the mains supply before cleaning Consult a service technician if the monitor does not operate normally when operating instructions of this manual are followed Package Your package includes the following items e The monitor e Pedestal e Power cord e Interface cable flying in End of life disposal Your new set contains materials which can be recycled and reused Specialized companies can recycle your product to increase the amount of reusable materials and to minimize the amount of materials to be disposed of Please inform yourself on loc
Download Pdf Manuals
Related Search
Related Contents
DB265 DB265S SIDEXIS XG Hubbell Electric Heater Company A User's Manual A Series UP90 UP120 UP150 UP170 Compressor Service Manual Otterbox iPhone 4 Impact Case LMS User Manual Manuel de l`opérateur KitchenAid KUIS18PNJB3 User's Manual Copyright © All rights reserved.
Failed to retrieve file