Pentair Fiberworks Wide Angle Lens User's Manual
Contents
1. FIBERworks Lens Assembly Installation Instructions STOP Read and follow all instructions We recommend that all FIBERworks lens assemblies be installed by trained and certified FIBERworks dealers only If you have any questions please call our service hot line Monday through Friday 7 30 a m to 4 30 p m at 800 831 7133 Installing the Lens Housing e FIBERworks lens housings are installed the same way water return fittings are installed DO NOT use excessive glue Excess glue can overflow onto the o ring sealing surface e Use only Pentair Pool Products FIBERworks lens housings Other fittings will not adequately seal conduit from pool Gunite cutback 14 water e Cut the conduit back as shown in the adjacent figure Dimension a should be one inch 1 for a FIBERworks Standard Gunite housing and one and a half inches 11 2 for a FIBERworks Invisible Gunite housing e Gunite To Photon Generator Conduit Plaster surface I Lens Selection for preOptifused and Bulk Cable Assemblies e Every lens assembly and preOptifused cable assembly now comes with a standard and wide angle lens See lens assembly drawing to identify different lens types Use the table below to select the appropriate lens for your application Lens Lens Position Type Shallow End Deep End All Side Wall Shadow Filler Spa Standard X Wide Angle X X X X e Posi2. not perform as intended e Make sure the lens o ring and spacer o ring if applicable are in position and the o ring sealing surface on the inner flange of the lens housing is clean e Continue feeding the cable until the lens assembly is about 1 2 away from the seated position e Place the lens retaining nut onto the lens and PUSH the lens into place e Hand tighten the lens using the lens tightening tool until the o ring is seated For Standard Gunite and Fiberglass lens housings which do not use the spacer and spacer o ring hand tighten the lens retaining nut turn past the seated o ring position For Invisible Gunite and Vinyl Liner housings which use the spacer and spacer o ring hand tighten the lens retaining nut 1 2 turn past the seated o ring position CAUTION DO NOT over tighten lens retaining nut Damage to lens assembly may result in leakage of pool water into conduit Save These Instructions 4 04 02 Instruction P N 99293000 Rev B Pentair Pool Products 1620 Hawkins Ave Sanford NC 27330 919 774 4151 10951 West Los Angeles Ave Moorpark CA 93021 805 523 2400
3. tioning on the pool spa wall is the same for both lens types Follow the recommendations in the Photon Generator Installation and Service Manual for proper lens positioning e DO NOT use any gel on the wide angle lens This will inhibit the light dispersion capabilities of the lens PreOptifused cable assemblies come with the standard lens and Optifusion gel Wipe excess gel off of cable face with a clean cloth before installing the wide angle lens e Anew lens tightening tool with longer pins p n 21006500 will be required to install the wide angle lens Installing the Cable and Lens Subassembly for preOptiFused and bulk cable applications e Feed the AmerGlow cable through the conduit leaving one foot of extra cable at each end e If using bulk cable assemble the lens subassembly as shown in the figure below Terminate the cable using the OptiFusion process as described in the full instructions packed with the Photon Generator or OptiFusion Termination Kit Any other process may dramatically reduce light output Wide Angle Standard Seal nut o ring L L ens ens Grommet 1 16 at gt Compression nut a FIBERworks lens housing N spacer with o ring use Lens retaining Invisible Gunite shown with Invisible Gunite and Lens o ring nut Vinyl Liner lens housings CAUTION DO NOT use Optifusion gel on the wide angle lens The gel will inhibit the light dispersion capabilities of the lens and the lens will
Download Pdf Manuals
Related Search