Nortel Networks Control Clamp EMC User's Manual
Contents
1. NORTEL 209823 A NETWORKS Installing the EMC Control Clamp The EMC Control Clamp must be placed no further than 3 7 cm 1 1 2 inches from the connector located on the PCMCIA card The cable must pass through the clamp three times to function properly To attach the EMC Control Clamp to the Ethernet cable follow these procedures 1 Open the clamp by placing your thumb nail into the side of the clamp that has the edge on it Pull out and lift the top of the clamp 2 Place the Ethernet cable through the center of the clamp Adjust the cable to make sure you are within 3 7 cm 1 1 2 inches of the PC card connector 3 Holding the cable in the clamp with your thumb wrap the Ethernet cable around XxX and through the center of the clamp two gt AS more times Se 2 4 Hold the Ethernet cable together in the center of the clamp and close the clamp until it snaps shut 5 Connect the cable to the port on the PCMCIA card June 2000 2 0 9 8 2 3 E A R V 0 1
Download Pdf Manuals
Related Search