NEC Express5800/120Rg-2 Release Notes
Contents
1. List of Notices Notices Models Note when using Remote Management Card N8115 01 N8115 02 When using modem for Express Report Service use serial port A lt supplement gt When using serial port B for example UPS do the setting as below In EXPRESSBUILDER menu System Management Function gt System Management Setting gt Configuration gt Change gt Common Set Alert and Remote Control WAN Direct as Disable Default setting is Disable Note for Seamless set up with SCSI HostRAID On Board RAID Configuration Installation procedure is as follows 1 When SCSI back up device is connected take off cable connection 2 Start SCSI Select Utility menu in POST set the HostRAID function on both of SCSI A B as Enable and do the installation Refer to the User s Guide for how to set the HostRAID function 3 After finishing installation connect back up device with cable 4 Start SCSI Select Utility menu in POST set the HostRAID function on the channel which is connected to the SCSI back up device as disable Refer to the User s Guide for HostRAID setting Note when using HostRAID configuration on Windows 2000 Advanced Server SP4 if procured installed and supported by customer Memory capacity should be 6GB or less 6GB is supported Note when using LAN for Management When using LAN for Management for example Wake On LAN2. SCO OpenServer is a trademark of Caldera Systems Inc All other product brand or trade names used in this publication are the trademarks or registered trademarks of their respective trademark owners September 2004 Copyright 2004 NEC Solutions America Inc 10850 Gold Center Drive Suite 200 Rancho Cordova CA 95670 All Rights Reserved Express5800 120Rg 2 System Release Notes The Express5800 120Rg 2 System Release Notes provide up to date information on your system These notes also provide additional valuable information about your system that was not included in the user s guide Please read these notes in their entirety CONTENTS Introduction AN 3 General Commenls 28 ouyioiuseaecva savas een ee esse ee 3 DONATIO NIEN AAEE E EE EAE E A E AE E E AE E E E 3 EXPRESSBUIEDER AE E E NE E E ne ee EE E E EE 3 Notices and Restrictions ccccccsccscccssessssececscssssscssecccscsesssessseccecsesseessssccecsesseesessseeceesssesssssesceesseessssess 4 Introduction These System Release Notes cover the following topics General Comments m Advisories m Notices and Restrictions General Comments The following general comments apply to this server Versions of the Network Operating Systems tested and recommended Windows 2003 m Microsoft Windows 2000 and NTO 4 0 are not supported m SCO OpensServer 5 06 is not supported Advisories EXPRESSBUILDER The foll
3. System Release Notes Express5800 120Rg 2 System Release Notes PN 455 01716 000 Proprietary Notice and Liability Disclaimer The information disclosed in this document including all designs and related materials is the valuable property of NEC Solutions America Inc and or its licensors NEC Solutions America Inc and or its licensors as appropriate reserve all patent copyright and other proprietary rights to this document including all design manufacturing reproduction use and sales rights thereto except to the extent said rights are expressly granted to others The NEC Solutions America Inc product s discussed in this document are warranted in accordance with the terms of the Warranty Statement accompanying each product However actual performance of each product is dependent upon factors such as system configuration customer data and operator control Since implementation by customers of each product may vary the suitability of specific product configurations and applications must be determined by the customer and is not warranted by NEC Solutions America Inc To allow for design and specification improvements the information in this document is subject to change at any time without notice Reproduction of this document or portions thereof without prior written approval of NEC Solutions America Inc is prohibited Trademarks Windows 2003 and Windows NT are registered trademarks of Microsoft Corporation
4. or the alert function via LAN using Remote Management Card use LAN 1 port LAN 2 port should not be used as LAN for management If you have any questions about this document please contact your sales representative 4 Express5800 120Rg 2 System Release Notes
5. owing advisories apply to EXPRESSBUILDER Windows 2003 must be installed using EXPRESSBUILDER Express Setup to take full advantage of NEC specific software for your server Note This advisory does not apply if your operating system was preloaded at the factory If you already have an operating system installed when creating a maintenance partition EXPRESSBUILDER will warn you of the existing partition If you want to preserve the installed operating system do not create the maintenance partition or the existing operating system will be overlaid by the maintenance partition The Administrator Menu in the System Information Management segment of the Offline Maintenance Utility is accessible only by NEC authorized service representatives EXPRESSBUILDER operates in floppy emulation mode The emulated floppy drive portion of your system CD ROM is designated Drive A and the remaining portion s of the CD ROM is designated Drive Q Your system diskette drive is Drive B After creating the Off line Maintenance Utility diskette EXPRESSBUILDER prompts you to remove the diskette from Drive B At this prompt remove the diskette from your diskette drive Express5800 120Rg 2 System Release Notes 3 Notices and Restrictions Express5800 120Rg 2 Notices and Restrictions This document describes the restrictions on Express5800 120Rg 2 Please read the list of notices below carefully to ensure that they are followed
Download Pdf Manuals
Related Search